Washer Dryer Combo Guard, Shield, Barrier Parts

This replacement shield is a direct-fit protective cover that restores the appliance's factory protection for internal components. It prevents contact with sensitive parts and helps keep wiring and controls clear of debris. What it does:

• Protects wiring, controls and nearby components from heat, moisture and debris.
• Restores the original barrier that helps prevent accidental contact with moving or hot parts.
• Replaces cracked, broken or missing shields that can lead to rattling, exposed components or interference.
• Helps maintain appliance safety and quiet operation when installed correctly.

• One replacement shield

• Always disconnect power to the appliance before starting any repair.
• Handle replacement shield carefully — edges may be sharp; use gloves and basic hand tools.
• Retain and reuse original fasteners unless new hardware is specified; ensure shield is properly seated and secured.
• Do not operate the appliance with shields or covers missing.

This replacement sleeve fits over a rotating shaft to reduce friction and protect the mating surface, helping restore smooth operation and reduce noise. Use when a worn sleeve causes rubbing or uneven movement. What it does:

• Acts as a bushing to prevent metal-to-metal contact on a rotating shaft
• Reduces friction and wear on the shaft and surrounding components
• Helps stop rubbing, scraping, or squeaking noises caused by a worn sleeve
• Restores proper alignment for smoother, quieter operation

• Disconnect power (and gas, if applicable) before starting any repair
• Use basic hand tools; no special training required for most installations
• Inspect the shaft and mating surfaces; replace if excessively scored or damaged
• If press-fit, install carefully to avoid damaging the new sleeve; do not use solvents as a substitute for proper fit

This replacement sleeve is a small shaft bushing that helps the drum/shaft rotate smoothly and keeps moving parts aligned to reduce wear and noise. It restores proper fit where a worn sleeve causes rubbing or play. What it does:

• Acts as a bearing surface between the shaft and housing to reduce friction
• Helps prevent metal-on-metal contact that can cause squeaks or scraping noises
• Restores correct alignment to reduce wobble or uneven drum movement
• Protects surrounding seals and components from premature wear

• One sleeve

• Disconnect power before starting and follow the appliance service manual for disassembly steps
• Inspect adjacent parts (shaft, bearings, seals) and replace if worn to ensure long-term performance
• Use proper tools and keep track of fasteners; some disassembly of the drum or cabinet may be required

This replacement overflow shield directs excess water away from sensitive components to help prevent leaks and water damage in the appliance. It restores proper drainage protection when the original shield is cracked, warped, or missing. What it does:

• Channels overflow or stray water away from critical areas to reduce risk of leaks
• Replaces damaged, cracked, or missing overflow shielding
• Helps maintain proper drainage pathways and component protection
• Commonly used when you see water pooling or dripping near the shielded area

• One overflow shield

• Inspect surrounding seals and fasteners; replace any that are damaged before installing the new shield
• Installation typically requires basic hand tools; secure the shield in the original mounting points
• Disconnect power to the appliance before starting work and restore power only after reassembly

This replacement shield is a molded protective cover that helps keep internal components safe from heat, moisture and debris, preserving appliance performance and preventing premature wear. What it does

• Covers and protects wiring, terminals or other internal parts from direct heat and debris
• Helps prevent electrical shorts by shielding sensitive components
• Reduces possibility of part-to-part contact and vibration noise
• A damaged or missing shield can allow exposure, burning, or abnormal noises

• Disconnect power to the appliance before starting any repair
• Handle edges carefully; wear gloves to avoid cuts on sharp metal
• Verify correct orientation against the existing shield before fastening

Kit includes 2 sleeves.