Washer Screws, Nuts, Washers

This washer screw secures internal components and panels. Replace if stripped, missing, or damaged during repairs to ensure proper assembly and fitment.

Panel mounting screw for laundry centers. Secures control panels, trim pieces, and access panels. Replace missing, stripped, or damaged screws.

A standard M3 hex nut used to secure compatible M3 bolts and studs in appliance assemblies. Small but essential, it restores proper fastening where a worn, stripped, or missing nut causes loose panels or components. What it does:

• Secures M3 threaded fasteners to hold panels, brackets, or small components in place
• Replaces missing, stripped, or corroded nuts that allow vibration or movement
• Helps stop rattling, misalignment, or intermittent electrical/contact issues caused by loose parts
• Used wherever an M3 nut is specified by the appliance manufacturer

• Disconnect power and follow appliance safety instructions before accessing internal parts
• Use the correct M3 bolt and matching thread engagement; avoid cross-threading
• Tighten snugly but do not overtighten to prevent stripping threads or damaging parts
• Replace any accompanying damaged fasteners or hardware for a reliable repair

This motor mounting screw secures the motor to the appliance chassis so the motor stays aligned during operation. It's a direct-fit fastener that replaces worn, stripped, or missing motor screws to restore secure motor mounting. What it does:

• Fastens the motor to the appliance frame to maintain correct motor alignment and stability
• Prevents motor movement that can cause vibration, noise, or premature wear
• Replaces missing, damaged, or corroded motor mounting hardware
• Helps restore reliable operation after motor service or reassembly

• Disconnect power before servicing the appliance to avoid electrical shock or injury
• Use the correct screwdriver or socket to avoid stripping the screw head
• Inspect mating threads and replace any damaged hardware or stripped inserts before final installation
• Tighten to secure fit; avoid over-tightening which can strip threads or crack housings