Washer Spring Parts

This left lid spring replaces the factory spring that helps support and counterbalance a top-load washer lid so it opens and closes smoothly and stays open when lifted. Restores proper lid positioning and reduces slamming. What it does:

• Provides lift support and counterbalance for the washer lid.
• Helps the lid stay open instead of falling or slamming shut.
• Reduces binding and uneven lid movement during use.
• Commonly replaced when the lid drops, slips, or feels loose.

• One left lid spring.

• Disconnect power and unplug the washer before starting any repair.
• Support the lid while removing/installing the spring to prevent injury or damage.
• Use needle-nose pliers or a spring tool; avoid overstretching the spring during installation.

This leg spring is the replacement spring used with the appliance's leg/leveling support to secure and stabilize the lower corner. It restores proper support and reduces tilting, rocking, or uneven leveling. What it does:

• Secures the leg or leveling assembly to the appliance chassis to maintain proper height and position
• Helps prevent excessive vibration, rocking, or uneven operation caused by a loose or broken spring
• Restores correct tension in the leg mounting hardware so the appliance sits level
• Common symptom: appliance leans, rocks, or has an unstable foot under load

• One leg spring

• Disconnect power and water before servicing and ensure the appliance is empty and stable
• Support the appliance with a jack or blocks to relieve weight from the leg before removing/installing the spring
• Use pliers and gloves to handle the spring; take care to avoid pinch points or sudden release of tension
• Verify leg alignment and level after installation and test stability before putting the appliance back into normal use

This spring hanger secures a suspension spring to the washer's cabinet/frame, supporting the tub assembly and helping control vibration. Replace a cracked or broken hanger to restore stable spin performance and reduce banging or shaking.

• Provides the mounting point for a suspension spring that helps carry the tub's weight
• Helps keep the basket balanced and limits vibration during spin
• Failure symptoms can include excessive shaking, loud banging, out-of-balance stops, or a sagging/leaning tub
• Visible cracks, deformation, or broken mounting tabs indicate the hanger should be replaced

• Disconnect power and water supply; access the hanger location per your model's service procedure
• Support the tub and control spring tension with locking pliers; wear gloves and eye protection
• Move the suspension spring to the new hanger and secure it in the same orientation
• Reassemble, level the washer, and run a test spin to verify smooth operation