Washer Tub Ring Or Cover, Counterweight

This balance weight stabilizes the washer drum to reduce vibration and keep the washer steady during spin cycles. Replacing a worn or damaged weight restores smoother operation and reduces shaking and noise. What it does:

• Adds mass to the washer frame/drum assembly so the tub stays balanced during spin
• Helps prevent excessive vibration, banging, and movement during high-speed spins
• Reduces noise caused by an unbalanced load or damaged weight
• Supports proper drum alignment to avoid premature wear on bearings and suspension parts

• One balance weight

• Always unplug the washer before starting any repair to avoid electrical shock
• Support the drum/tub when removing or installing the weight to prevent component damage
• Reuse or replace any mounting hardware only if explicitly specified by the manufacturer
• If vibration persists after replacement, inspect suspension, shock absorbers, and mounting points

This balance weight assembly replaces the factory counterweight that helps keep the appliance door properly balanced for smooth opening and closing. Restores correct door alignment and reduces sag or uneven closing. What it does:

• Counterbalances the door to maintain proper alignment and even gaps
• Helps the door stay open at intended angles and reduces unexpected slamming
• Reduces strain on hinges and related hardware that can cause premature wear
• Commonly used when door sag, uneven closing, or misalignment is observed

• Disconnect power (and water, if applicable) before beginning service
• Follow the appliance service manual for correct removal of the door or trim to access the weight
• Use appropriate hand tools and support the door to prevent dropping or injury

This counterweight helps balance and stabilize an appliance door, restoring proper closing and alignment for safer, smoother operation. Replace a worn or missing weight to reduce door sag and improve door return. What it does:

• Balances the door to help it close evenly and stay aligned
• Reduces door sag, dragging, or uneven gaps
• Restores correct door return and hinge tension
• Helps stop doors from slipping open or not seating fully

• One counterweight

• Disconnect power and empty the door before starting
• Support the door or hinge assembly while removing/installing the weight
• Basic hand tools required; follow the appliance service manual for exact steps

This front/bottom counterweight stabilizes and balances the appliance door, helping maintain proper alignment for smooth opening and closing. It replaces a worn or missing weight to reduce door sag and improve fit. What it does:

• Balances the door to prevent sagging and uneven gaps
• Helps the door close securely and stay aligned
• Reduces rubbing or scraping at the hinge area
• Restores proper door feel and reduces noisy operation

• Disconnect power to the appliance and remove any contents from the door before beginning
• Installation may require removing the door trim or accessing the lower hinge area; keep all fasteners
• Handle the weight carefully to avoid pinching fingers; use proper tools and support the door during reassembly

This outer tub cover protects the washer's tub assembly and helps contain water while keeping internal components free from debris. Replacing a worn or damaged cover restores a secure seal and helps reduce unusual noises or leaking. What it does:

• Covers and protects the washer tub assembly from debris and wear
• Helps maintain a proper seal to contain water during wash cycles
• Prevents contact between the spinning tub and cabinet components
• Can reduce banging or rubbing noises caused by a damaged cover

• One outer tub cover

• Disconnect power and water before starting any repair
• Remove washer cabinet or access panels to reach the tub cover
• Handle part carefully to avoid damaging mounting tabs; use proper fasteners shown in the OEM guide