This cap is a small protective cover used in select appliances. It helps secure and seal its mating component, preventing leaks, debris intrusion, or loosening during normal operation.
- Maintains a secure seal/cover over the designated fitting or opening
- Helps prevent leaks and contamination in the covered area
- Can resolve issues like minor leaks, loose or missing cap, or rattling noises
- Restores proper fit and finish after the original cap is lost or damaged
What's included: 1 cap Install notes:
- Disconnect power and shut off water or gas supply before servicing
- Note the orientation of the original cap for correct placement
- Hand-tighten only unless the OEM specifies otherwise; do not overtighten
- Inspect the mating surface or threads for damage before reinstalling
Do-It-Yourself Stories from Customers like You
The bolt holding stator/rotor sheared off in shaft Timothy P. • Edmonds , WA • March 20, 2020
Removed the back cover. (Glad I used my power tool to remove all the screws) I then removed the sheared off part of the bolt using drill and easy-out tool. It was a straightforward install of the new bolt. I added a little bit of blue Loctite even though the bolt already had some dry thread sealer. I torqued it down enough to hold everything snug. I also replaced the cap on the water pump filter as I cracked it when I removed it. Tip: Don't use pliers even with a rag to cushion or be more...
Read more