Adaptor Or Connector

Water line connector for side-by-side refrigerators. Replaces cracked, leaking, or broken connectors in the water supply system. Essential part.

Adapter for upgrading from metal canister to modern cartridge water filters. Install once when switching filter types—reusable for future changes.

This coupling is a small connector piece used inside the refrigerator to join two rotating or moving components together. It transfers mechanical motion between parts and helps ensure proper operation of internal mechanisms. Replace this coupling if it becomes cracked, worn, or stripped, which can cause connected components to stop functioning or operate intermittently.

This is a tube connector fitting used in a refrigerator's water supply line. It joins sections of water tubing to maintain a secure, leak-free connection for the ice maker or water dispenser system. Replace this connector if you notice water dripping or pooling beneath or behind the refrigerator, or if the fitting is cracked or no longer holds a tight seal.

Water pipe connection assembly for refrigerators. Installs between water supply and internal systems. Replace if cracked, broken, or leaking.

This drain fitting connects to the refrigerator's internal drain line, directing condensation and defrost water away from the interior and into the drain pan. It ensures proper water flow to prevent pooling or leaks inside the compartment. Replace this fitting if you notice water accumulating at the bottom of the refrigerator, leaking onto the floor, or if the existing fitting is cracked or clogged.

Water line fitting connector for side-by-side refrigerators. Replaces cracked, broken, or leaking fittings that connect water supply lines.

Wire harness connector for refrigerator electrical systems. Replaces damaged, corroded, or loose connectors. Installs on internal wiring harnesses.

Quick connect adapter for refrigerator water line tubing. Installs between water supply and filter or dispenser. Replace if cracked, leaking, or broken.

Rear panel connector for refrigerators. Installs on the back panel to connect components. Replace if cracked, broken, or missing for proper assembly.

This rubber grommet seals and cushions the dishwasher water tube where it passes through the tub or panel, helping prevent leaks and reduce tube movement. It's a small but important part for reliable water routing. What it does:

• Creates a watertight seal around the water tube to help prevent leaks and water damage.
• Cushions and secures the tube to reduce vibration, rubbing, and wear.
• Helps keep the water tube properly routed and positioned during operation.
• Commonly replaced when you see leaking near the tub, water pooling under the unit, or a loose/misaligned tube.

• One rubber water-tube grommet

• Disconnect power and shut off water supply before servicing the appliance.
• Access the area per your model's service instructions (lower kickplate or cavity panel removal may be required).
• Remove the old grommet and press the replacement into the tub or panel opening; then re-seat the water tube through the grommet until it fits snugly.
• After reassembly, restore power and water and run a short cycle to check for proper routing and leaks.