Dishwasher Dispenser Parts

Fix dishes not cleaning properly or spotty glassware with this dishwasher detergent and rinse aid dispenser. Restores proper soap release timing.

Protective housing cap that encases the dishwasher thermostat. Replace if cracked, broken, or missing to properly shield temperature monitoring components.

Fix leaking or improper detergent dispensing caused by cracks or mineral buildup. This washer dispenser tank restores proper detergent flow.

Protective cover cap for dishwasher installation. Replaces cracked, broken, or missing caps. Ensures proper coverage and protection of components.

Molded trim piece that positions and protects adjacent moving parts in your dishwasher. Replace if cracked, broken, or missing to restore alignment.

This lid is the washer's top cover that protects internal components and keeps clothes contained during operation. It restores the washer's enclosure and helps maintain safe, splash-free cycles. What it does:

• Covers the washer tub and control area to prevent splashes and keep items inside during cycles
• Provides the surface that the lid latch/switch engages to enable normal operation
• Replaces cracked, warped, or missing lids that allow debris in or interfere with closing
• Helps maintain the appliance's appearance and proper function of the top access

• Disconnect power before starting any repair to avoid electrical hazard
• Lift off or unbolt existing lid per your model's service instructions; alignment may be required for proper closure
• Keep screws and small parts organized; some models use hinge pins or clips that must be reinstalled
• If your washer also has a separate lid latch or switch, inspect and replace it only if listed as defective

Detergent not dispensing or dishwasher door won't close? This dispenser module releases detergent at the right time. Moderate DIY repair difficulty.

Replaces a cracked, broken, or missing dishwasher vent cover that mounts on the inner door panel. Shields the exhaust opening and directs airflow.

This middle spray arm bracket secures the mid-level spray arm to the upper rack, keeping it centered and aligned so it spins freely and delivers even spray coverage for reliable cleaning performance.

• Supports and stabilizes the middle spray arm beneath the upper rack
• Maintains proper clearance for smooth rotation and spray pattern
• Replace if cracked, warped, or worn
• Common symptoms: middle arm falls off or won't spin, wobbles, scraping noises, or poor cleaning on the upper rack

• Disconnect power to the dishwasher before servicing
• Slide out the upper rack; release tabs or fasteners to remove the old bracket
• Transfer the spray arm to the new bracket and snap or secure it in place
• Spin the arm by hand to ensure free rotation before running a cycle

Connects dishwasher wiring to the water inlet valve. Replace if the plug is burnt, brittle, loose, or corroded to restore a secure electrical connection.

Replacement front cover for dishwasher control module. Needed when plastic is cracked, broken, or switch actuators are worn or missing. Protects control board.

Soap dispenser won't open? Replace the bi-metal thermal actuator that releases the detergent door. Takes about 15 minutes with basic tools.

Replace your dishwasher's dispenser top tower cap when it's broken, cracked, or missing. This visible cover snaps onto the upper dispenser assembly.

Replaces a cracked, broken, or missing water inlet valve trim cover on your dishwasher. Conceals and protects the inlet valve and hose connections.

Factory replacement access panel cover for dishwashers. Protects internal wiring and controls from dust and accidental contact. Needed when cracked or missing.