Frigidaire Bumper, Bushing, Grommet Parts

Push-in plug button that covers openings in the oven bottom panel. Replace if cracked, missing, or broken to keep debris out and maintain a clean finish.

Rubber grommet plug that seals the light switch opening in your range control panel. Replace if cracked, torn, missing, or no longer providing a tight seal.

White handle spacer bumper for ovens and ranges. Replaces worn, cracked, or missing spacers between the handle and door. Essential for proper fit.

Suspension bushing for washer tub assembly. Replaces worn, cracked, or missing bushings that cause excessive noise or tub movement during cycles.

Plastic push mount rivet that secures the microwave stirrer cover in place. Replace if the original rivet is broken, cracked, or missing.

Replacement cushion for your microwave door or cabinet. Installs to provide cushioning and prevent impact damage. Order a new cushion if worn or missing.

Rubber grommet for air conditioner mounting and vibration dampening. Replace if cracked, torn, or missing to restore proper unit installation and support.

Rubber bumper block for dishwasher racks. Installs on rack ends to cushion and protect against cabinet damage. Replace when cracked, worn, or missing.

Bumper block for dishwashers. Mounts to the door or frame to cushion closing and prevent rattling. Replace if cracked, broken, or missing.

This snap bushing is a push-in grommet that secures and protects wiring where it passes through sheet metal openings, helping prevent wire chafing and wear. It's a simple replacement that restores proper wire routing and protection. What it does:

• Holds wiring or harnesses in place at panel openings to prevent rubbing and abrasion
• Cushions wires against sharp edges to reduce the risk of wire damage and shorts
• Maintains correct wire routing to prevent pinching when panels are reassembled
• Common symptom: visible chafed insulation or loose wiring at an opening

• One snap bushing (quantity: 1)

• Disconnect power to the appliance before beginning any work to avoid shock or injury
• Access the panel or opening where the wiring passes through; remove any retaining screws or clips as needed
• Press the bushing into the hole until it snaps fully into place, then route the wire through the center
• Inspect surrounding wire insulation and replace or repair any damaged wiring before reassembly

This is a retainer clip used to secure internal components in place within a freezer. It holds parts firmly in position to prevent shifting or rattling during normal operation. Replace this retainer if the original is cracked, broken, or missing, which can cause loose or misaligned components inside the unit.

Rubber bushing that cushions and supports the washer tub assembly. Replace if worn, cracked, or causing excessive vibration during the spin cycle.