Frigidaire Switch

Fix a dishwasher that won't heat or dry properly with this bimetal temperature switch. Common repair for heating issues. Moderate DIY difficulty.

Replace your range infinite switch if burners won't heat, overheat, or cycle improperly. Direct-fit control switch for smooth temperature regulation.

Range burner won't heat or stays on high? This infinite switch controls surface element temperature settings. Common fix for heat regulation issues.

Dryer not heating or overheating? This resistor regulates temperature control in your dryer's heating system. Simple DIY replacement part.

This wiring harness routes power and signals between the appliance's control and various electrical components, restoring reliable electrical connections and helping the appliance operate as designed. Use it when wiring is damaged, corroded, or intermittent. What it does:

• Delivers power and signal paths between control boards, switches, and motors
• Restores lost or intermittent electrical connections that can cause failure to start or run
• Replaces burned, frayed, or broken wires and damaged connector terminals
• Helps eliminate arcing, shorts, and communication errors caused by faulty wiring

• Always disconnect all power (unplug or shut off breaker) before starting repairs
• Match connectors and wire routing to the original harness; avoid stretching or pinching wires
• Inspect mating connectors and terminals for damage before installation; replace any damaged parts
• If connectors are tight or corroded, clean or replace them rather than forcing connections

Refrigerator light not turning on or staying on? This light switch controls interior lighting when the door opens and closes. Easy 15-minute fix.

If your range burner won't heat, stays on high, or cycles incorrectly, the infinite switch likely failed. This direct-fit part restores precise heat control.

Fix range display issues, unresponsive controls, or error codes with this control board assembly. Common repair for ranges that won't start or heat properly.

Warming drawer not heating or won't turn on? This control switch regulates temperature settings. Moderate DIY repair requiring basic tools and care.

Oven won't heat to the right temperature or temperature control unresponsive? This thermostat selector switch restores precise temperature adjustment.

Fix a microwave that won't start or stops mid-cycle with this monitor switch. Common safety component failure. Moderate DIY repair with basic tools.

Range burner not heating or stuck on high? This infinite switch controls surface element temperature settings. Common DIY repair for heat control issues.

This is a replacement light switch that controls the appliance interior lamp so the light turns on and off when the door opens. Restores normal lighting for safe, convenient access to contents. What it does:

• Opens and closes the circuit to the interior lamp when the door is opened or closed
• Replaces a worn or failed switch that prevents the light from turning on
• Stops lights from staying on continuously if the door-switch has failed
• Works as a direct replacement for the original factory switch

• Disconnect power (unplug appliance or shut off breaker) before starting any work
• Replace from the door or cabinet frame access area; small trim or fasteners may need removal
• Handle wiring carefully and reconnect terminals exactly as removed