General Electric Door Stop Or Cam Riser

This white stop door replaces the dispenser stop/door that controls access to the ice/water chute, helping restore proper dispenser operation and reduce sticking or unwanted discharge. Designed to match the original OEM fit and appearance. What it does

• Seals and releases the dispenser opening so ice or water is dispensed only when the door is actuated
• Replaces a cracked, warped, or jammed stop door that can cause sticking or partial openings
• Helps prevent accidental drips or debris entering the dispenser chute
• Restores a smooth, aligned door movement for reliable dispensing

• One white stop door

• Disconnect power to the appliance before starting any repair
• Remove dispenser housing or outer door per the service manual to access the stop door
• Inspect the actuator and mounting tabs for damage; replace if worn to ensure proper operation
• Use basic hand tools;

White plastic door stop cam that controls refrigerator door closure. Installs on fresh food compartment. Replace if cracked, broken, or worn.

Door stop plate for side-by-side refrigerators. Mounts on the door hinge to control door swing and positioning. Replace if cracked or worn.

White plastic cam closure that aligns and secures the freezer door in the hinge area. Replace if cracked, broken, or worn to restore proper alignment.

Replaces a broken or missing dispenser door stop on side-by-side refrigerators. Closes and seals the ice/water dispenser opening when not in use.

White door stop cam riser for refrigerator freezer doors. Replaces cracked, broken, or missing door stops that prevent proper door closure and alignment.

Replacement door stop for your refrigerator. Installs on the door hinge to limit swing and prevent damage. Order now if your original is cracked or missing.

Door stop cam riser for refrigerator doors. Installs on hinge assembly to control door swing and prevent damage. Replace if cracked, broken, or missing.

This shear pin secures the washer agitator to the drive shaft and protects the transmission by designed failure when the agitator binds. It's a small, low-cost part that prevents costly gear or motor damage. What it does:

• Locks the agitator to the drive shaft so the washer can agitate and spin
• Designed to break (shear) if the agitator is jammed, preventing transmission or motor damage
• Commonly replaced when the agitator spins freely or the washer won't agitate
• Small part that restores proper mechanical coupling between agitator and drive

• One shear pin

• Disconnect power and water before starting any repair
• Access usually requires removing the agitator; follow your model's service instructions
• Verify shaft and agitator mating surfaces for wear or damage and replace if needed

White freezer door stop plate installs on the cabinet to secure the door. Replace if cracked, broken, or missing to restore proper door alignment.

Replacement door stop for your refrigerator's freezer compartment. Holds the door at the correct angle when opened. Replace if cracked, broken, or missing.

Controls freezer door linkage assembly alignment. Replace if the actuator is cracked, broken, or worn, causing misaligned or sticking linkages.

Replacement door stop for your freezer. Prevents door from opening too far and protects hinges. Replace if cracked, broken, or missing. Easy install.

Door stop cam riser for side-by-side refrigerators. Installs on the door hinge assembly to control door swing and positioning. Replace if cracked or worn.

Door stop cam riser plate for side-by-side refrigerators. Installs on the door hinge to control door swing and position. Replace if cracked or broken.

Door stop assembly that secures and positions your refrigerator door. Replace if the original is cracked, broken, or missing to restore proper door alignment.