General Electric Buzzer Or Chime

This lid actuator engages the washer's lid switch or lock when the lid closes, signaling the control that it's safe to run. Replacing a worn or broken actuator restores reliable lid detection for wash and spin cycles.

• Engages the lid switch/lock when the lid is closed
• Signals the control to allow the washer to start and spin
• A damaged or missing actuator can lead to "lid open" errors
• Common symptoms include won't start, won't spin, or lid lock light flashing

• Disconnect power before servicing
• Access the lid switch/lock area; remove the failed actuator
• Install the new actuator, aligning it to the original mounting points; reuse existing hardware
• Close up and test lid detection before running a full cycle

Fixed buzzer that replaces the appliance's audible tone generator in the control panel, restoring beeps and alerts for cycle completion and fault signals. Simple swap that returns audible notifications used during normal operation. What it does:

• Produces the control panel's audible tones for end-of-cycle alerts and warnings.
• Replaces a buzzer that has stopped sounding or produces weak, intermittent, or distorted beeps.
• Helps restore audible error/fault notifications so you can respond to appliance alerts promptly.
• Works as the control panel's dedicated tone generator — pairs with the appliance's existing electronics.

• Disconnect power to the appliance before beginning any service to avoid electrical shock.
• Access the control panel per your model's service instructions and note wire/harness positions before removal.
• Disconnect the buzzer wiring or harness, remove mounting fasteners, and install the replacement in the same orientation.
• Reassemble panels, restore power, and run a test cycle to audible operation.

This genuine replacement part is a water valve for refrigerator ice makers. The water valve supplies water to the ice maker to fill the water reservoir. If the icemaker is no longer operating properly and no longer dispensing ice, it might mean that the water valve needs to be replaced. Thankfully, replacing this part is an easy repair. To begin, make sure all the power is turned off to the appliance. Open the freezer door where the water dispenser is located. Remove the inner panel of the door by unfastening the screws that secure it. Once the panel has been removed locate the old water valve and release it from its mounting brackets. Once removed, replace with the new water valve. Reinstall the door panel and restore power to the refrigerator. This OEM part is compatible with General Electric, Hotpoint, and RCA brand refrigerators.

A replacement buzzer alarm that restores your refrigerator's audible warning system so you can hear important alerts. Helps make sure door-open, temperature or other alarm conditions are noticed early. What it does:

• Produces an audible alert tone for door-ajar, high-temperature, or other refrigerator warning signals
• Replaces a failed or silent buzzer to restore audible notifications
• Works as the appliance's alert source when control board signals an alarm
• Helps you notice problems sooner when the appliance is running but not operating normally

• Disconnect power to the appliance before starting any work
• Usually mounts with one or two fasteners and connects to the existing wiring harness
• Use basic hand tools; avoid forcing connectors to prevent damage