General Electric Range / Cooktop / Oven Parts

With the help of Wendee and Karen, we finally figured out my model numbers and which parts where correct. I ordered the parts and all arrived the next day except for the Broiler element which arrived in 2 days. I installed the new Baking Element myself. Took longer to figure out which curcuit braker to turn off. In about 30 minutes I had a brand new Baking Element in my oven working perfectly. On the following day, I installed the Broiler Element. That took a bit longer as it sits in a metal... Read more

We had searched everywhere for replacement knobs on my cooktop. We had even ordered some from other vendors, but they were wrong. I found AppliancePartsPros.com and they had them and were able to deliver them within 3 days of my order. Read more

Took top apart to find out that the problem was just the lens for the light was broken. Come to find out that the lens is what holds the light in place. When the lens broke the light fell down into the base of the cooktop. I bought a light and lens but for the price I could not go wrong. I cannot believe how fast and easy my order was handled!! Awesome company Read more

Fixed it in less than 10 minutes easy peasy just plug and play. Took the part you guys sold me and took the old part out, and put the new part on and just put two screws back in to secure the cooktop all set can't thank you, folks, enough. Read more

Removed the defective burner labeled the leads as to their location and coil connections. Replaced the connections to the corresponding locations, 1 to 1, 2 to 2 and the bridged terminal as it was. I noticed that the coils in the replacement burner were not wound in the same direction as the original burner and made note of this. I did not think much of this at the time, but on turning the power back on and lighting up the burners I noticed up they were not lighting up the corresponding... Read more

Replaced the sensor at the back of the oven. Read more

Bought the drawer support, unscrewed the screw with a socket wrench, installed the new drawer support, wala! Took 1 minute. Moral to the story, don't overload that bottom drawer. Metal cookie sheets or the broiler pan is okay, but not big ceramic baking trays, they're too heavy for the nylon drawer supports. Read more

Replaced control Element. This took less then 30 min and I am no pro(first time to do this repair). Read more

No tools necessary. Simply pull the old gasket free and install new one using the small metal clips in the gasket. Took less than five minutes. Easy. Read more

Our 25-year-old range's original Oven Bake Element melted itself. When it happened it looked like someone was using an arc welder in the oven. This seemed to be a potential DIY repair, especially after looking at the cost of a new range. So we Googled the oven's model number (GE JBP21GS2WH) and AppliancePartsPros.com was the top search return. (Way to go, SEO!) Clicking on this link brought up a web page of parts specifically for our model number with the parts sorted by popularity. The Oven... Read more

Would advise before doing this repair to watch the video for it. It is not a plug in connection anymore like older ovens. The key is to keep the connecting wires from the oven from falling or pulling into the inner wall of the oven. The wires may not come very far out away from the wall of the oven so make sure to secure them. The video shows a good way to do that. If you have an in wall oven this is very important because it would hard and time consuming to pull the oven out of the wall to... Read more

Looked for the parts at this site and ordered those need plus spares Read more

• Timer will not advance

Replaced above parts, easy to do, looks like a new stove. Needed to pry open knob stem slot segments very slightly to remove broken plastic from previous knobs. Spreading stem slot metal sides too much and they will break. With slots cleaned out, pinch stem sides almost together for new knobs to slide on. Customer service rep was helpful and parts delivery was next day as promised. Before contacting Appliance Parts Pros, I found their on-line customer reviews were much better than their... Read more

We ordered a new elimate, which was shipped the same day. Very good. Read more

My wife put the faceplate on the oven control while I accessed the display by pulling the oven out, unplugged it, and removed the rear cover. Only three nut head screws held the upper back panel. 4 nut screws hold the display onto the oven, they were easily removed. My wife took a couple photos of the rear wiring to ensure we plugged the new oven control in properly (there are a fair number of wires but they are color coded in most cases). Turns out we didn't need the photo. As we pulled a... Read more

Replaced the ignitor glow bar and deflector oven (which had a hole burned through it). Screws stripped upon disassembly of original deflector oven and needed to be replaced as well. Read more