General Electric Refrigerator Parts

• Freezer section too warm

New cond fan & new evap fan & new defrost heater unit Read more

• Fridge too cold
• Fridge runs too long

I went on you tube to try and figure out what might be causing this problem. It seemed that the problem was either the temperature thermostat or the defrost timer. I figured that seeing as I had never ever seen any frost in the freezer that the problem probably wasn't the defrost timer. So I ordered the temperature control thermostat, received it the very next day and in ten minutes removed the old one and installed the new one and we were good to go. It's been working just fine for the last... Read more

Replace with new drawer cover. Read more

• Fridge runs too long
• Door won't open or close
• Door sweating

I followed the directions on the video.....had to look at it a couple of time. Difficult to work lying on the floor for me, but the technique was spot on. I have now replace the door closing cams on the refrigerator door and the freezer door of the side by side unit. Thanks for such great instructions. Read more

Removing the bottom panel and watching the internals while the washer was running revealed a small drip from what appeared to be a plastic cam that was attached to a solenoid. The water was dripping from the shaft the cam attached to down into the solenoid. Being a DIY guy I pulled the washer out, turned it upside down and inspected the effected mechanism. It appeared that there was a seal on the shaft that was leaking. The water leaking into the solenoid caused it to rust and stick. A quick... Read more

Changed out the valve and cleaned the lines out Read more

Followed the steps in the video. Just ensure you slide the auger forward so it clears the housing before trying to remove it. Read more

After disconnecting power to the fridge, I first removed the ice maker/water dispenser/fridge control faceplate. This easily popped out using a flat head screw driver. Then disconnected the 3 wire harness connections to the control board. I next removed the plastic dispenser housing shield. There's only 4 screws that hold this on. Finally, I removed the Micro-switch, disconnected the two wire connectors and installed the replacement switch and reinstalled everything. The repair took only... Read more

I ordered a new glass shelf late Friday afternoon and it was on my doorstep by Saturday! I really appreciated this because I was without a shelf in my fridge and was running out of space. I simply set it in place and was done with the repair. The cleanup of tiny pieces of glass in my sink, garbage disposal, and all over the floor took more time than the repair. Thank you Appliancepartspros.com! Read more

The repair went great with the guidance from your website and the parts that we purchased! also the video was great! Read more

Part came in quickly. Fit right in. Read more

I ordered the parts I needed from Appliance Parts Pros which I found very easily. The installation was as easy as turning a few screws to attach the rails, putting the glass in place, and sliding the drawer back in place. Read more

My refrigerator is 13 yrs old and began to build up frost in the ice cube shoot and the water tube began to freeze up over night. The flapper door was not closing completely. I simply removed the control panel by pulling up and out on the bottom edge, the edge is only about 1/8 inch thick, so don't reach in to far. You should be able to feel a small division line between the control panel and the refrigerator. No screw driver was needed to expose the 4 mounting screws of the inner dispenser... Read more

• Ice maker dispenses too much ice

First - I am not a handyman so bear with me. Turned out not only the auger fins were broken off but also the ice dispenser crusher cover had cracks and breaks on it. First - AppliancePartsPros.com has awesome shipping. Because i didn't know right away the crusher cover was broken, I had to do two orders. Each order was received next day in afternoon. Video is great. Tells exactly how to do. There are two issues you will run into. Remembering the exact sequence of all the washers and... Read more

Ordered replacement part, and installed it. Read more

Replacement of the evaporator fan motor, fan blade, and grommets. The amount of disassembly to reach the part took most of the effort Read more