Kenmore / Sears Clip Or Clamp

Replace idler, motor mounting clamp and lock Read more

Our 19 year old Whirlpool dryer quit heating. After checking the thermal fuse, I found the ignitor electrically open. I bought an ignitor at a local store as there was a national holiday the next day and I did not want the dryer inoperative waiting several days for shipping. I can say AppliancePartsPros is MUCH cheaper for the identical Whirlpool genuine part. While changing the ignitor, I noticed there was an excessive amount of lint in the dryer, which was caused by worn drum seals. I ordered... Read more

Im not a repairman, so all my knowledge to fix my washer came from either youtube or online chats. I posted this to help the next dad trying to save a few bucks. Door sensor... Since door sensor worked correctly, verified that by starting washer with door open, and agitate cycle would not start until door was closed. Meaning door sensor worked correctly. Timer... In high spin cycle washer sounded correcltly spinning, but when opening door, drum was was not moving. So timer was triggering... Read more

I started by watching the video and it was very helpful. I would make one suggestion. On our model the weights on the tub sit very close to the front gasket. It is much easier to put the gasket on the tub before you put the weights on. Also, since the washer was tore apart, I replaced the hoses and seals and shocks since the machine is about 8 years old. The shocks made a huge difference. It spins like it did when it was new. Thanks for the video, it was very helpful. Read more

Shelving went in without a problem. Very simple. Checked the installation video anyway in case there was a trick to not breaking something. Learned that the nylon clips needed to be transferred and found one missing on another shelf, so ordered a replacement. The water valve was one I replaced some time ago but one of the solenoids was bad, confirmed with a meter (ohm reading is between 200-500; less than 200 or more than 500 is broken). Replaced it without a problem (becoming expert at... Read more

I went to your web site found the part using the model number of the washer machine. Also with the part picture, there was a video showing step by step instructions. They were very clear and was breeze replacing the hose.Doing this myself saved at least probably $150-200. Appliance repair shops quoted me around $80.00 just to come out. Then they mark up the price of the hose at least twice the cost of what I paid , They too have to order the part and come back to install. So the labor was what... Read more

• Leaking

The video was very helpful. the hardest part is getting off old rusted parts. I had to use a hacksaw to remove one of the old clamps. I had to open the bottom of the washing machine to remove of the other clamp. Putting the new parts on was easy. Getting everything apart was a challenge. Putting the new parts on was an easy 5 minute job. Read more

I was kind of guessing at the parts that I needed, but the parts diagrams were a huge help, and I narrowed it down to the bushing and stopper on the right door. I removed the door and was able to replace the parts pretty easily. Now the fridge door works good as new. Read more

New hose and clamp. Read more

Took the impeller out, removed the pump, replaced connector, put new clamps on, reassembled and checked for leaks. I just followed Arts video, went smooth. Wifes happy, things are good. Thanks AppliancePartsPros.com Read more

It was relatively easy, we took out the broken lid with the gasket then remove the clips, all of them were ok and we could use them again. Then we proceed to put the new lid with the gasket and use clips to fasten the lid. Read more

It easily snapped into place Read more

So I replaced the hi-temp thermostat and the problem is fixed. Read more