Kenmore / Sears Screws, Nuts, Washers

Took about 5 min to replace the handle with the parts ordered. Thank you for the fast service. Read more

Replaced the hinge receiver with a new one. The old one was bent slightly inside where it could not be seen. I think someone pushed the door down to far or fell on it. 2 screws to remove it, take out storage drawer and reach up little ways to remove and replace the receiver. Replace the 2 screws. The receiver comes with 2 screws but I ordered an extra ( never used it ). The sides of the receiver were spread just a tiny bit but were enough to cause a problem. Read more

I wasn’t sure where I could get parts for the fridge, Google brought me here. Super easy to look up model #’s and locate parts by type/location with the appliance map. I needed to change the racks and the doorstop. The racks were super simple. I would have succeeded with the doorstop too, but the holes at the bottom are stripped and the doorstop wasn’t secured correctly in the first place. So that’s frustrating, but appliance parts pros were easy to use, parts came quickly and The video from... Read more

Secured the inner and outer door together and screwed handle back in place. Read more

I took the machine screws out of the outer panel for the right side only. Then pull the panel back a bit to release the lips from the front of the machine and had immediate access to the internal assembly that housed mounting nut. Order the new parts from AppliancePartsPro.com during the Thanksgiving week. Still received via FedEx in short time due to their same day shipping - which was greatly appreciated and surprising. Most small part places take a while to get the product out the door,... Read more

Simple Repair. Read more

SELF. Read more

Start by removing the frame on the sides and bottom of the door. (Do not unscrew the corner screw holding the side frame and bottom together.) Be careful the glass will fall once the last screw is removed from the bottom so hold tight. Carefully remove glass and set aside. Remove top frame that held the handle. Once all the frame work and outer glass is removed unscrew the bracket that held the door handle from the door. Taking the top frame and bracket insert screw and washer and screw the... Read more

First, I took the whole thing apart and cleaned every spot...the main culprit seemed to be the float. It was pretty gunked up and seemed to be not working...after a good cleaning it was fine...but once I pulled the unit out and checked underneath I noticed the heating element was loose, leaking, and had burnt off the blade connecting ire. So I promptly bought this replacement, installed it in about 5 minutes, did a clean cycle, and shes back to normal...I love AppliancePartsPros.com, and use... Read more

It was easy to find the part on appliance parts pros. Once I found it I studied the diagram and determined that there were 3 screws in the drum that needed to be removed. I disconnected power and then removed 3 interior screws. Once I did that I removed the back cover and removed the single screw on the bottom side of the air duct that held it in place connected to the heat tube. I then reversed disassembly. I want to tell you this is a 2 person job. In order to assemble it you need to... Read more

We had a repair man come and tell us the needed repair at the cost of 70.00 I ordered the parts and saved money. Read more

Replacing the trim takes a little bit of alignment and light force. The trim slides over the glass panel of the door, with the glass sliding into plastic tabs. We kept the door nearly vertical (almost closed), lined up the tabs on the trim with the glass door, and used mild force to slide the trim down onto the glass door. (Also, we found that the tabs on trim we ordered were much bigger than the tabs on our broken trim. This is probably due to slight variations in Frigidaire's design over... Read more

Walk into the kitchen on 21 Sep. Eight year old Frigidaire refrigerator appears to be short cycling, controls are nonfunctional. Unplug it for a few minutes, plug it back in, appears to return to normal function. Return to kitchen half hour 45 minutes later it's short cycling again. Panel has codes on it (S or 5 E CE, later that changes to S or 5 Y CE). Research of codes says replace main board and control board. Not sure where this main board is. 22 Sep call appliance repair. "Soonest... Read more

Got the part from you in record time. Had it on 5 minutes, the world is back to normal. Thks Read more

Replaced "Ice Crusher Housing" and "Fixed Blades Spacer, both of which had broke. Read more