Kenmore / Sears Parts

Called appliance parts and asked, what was the fix. Told it was fill switch and that I could order it. I was amazed that I received the part the next day without even asking for overnight delivery. I installed the part in less then 20 min. Problem fixed.. Read more

• Will not stop filling with water

I removed two sheet metal screws to remove the panel above the washing machine lid. That exposed four more phillips drive sheet metal screws, after removing those the dashboard control panel is held by two smaller black screws slightly recessed in the lower corners. This allowed the panel to be pulled down from the top, revealing the back of the switch. At this point I took a picture of the wiring connections with my cell phone to make sure I put them on the new switch in the same... Read more

Replacing door switch. Read more

Replaced light switch Read more

• Won't start

By replacing the switch, the front right burner correctly turned on the igniter and worked. Repair took about 5 minutes. Very easy to do. Read more

The E32 diagnostic code that the Frigidaire washer was throwing after a quick water fill attempt was not in the supplied Data Sheet that came with the washer and Frigidaire would not provide and updated Data Sheet because, "it's a liabiliity issue" was their statement, but they did tell me that the problem was in the Fill Pressure Sensor/Wire Harness or the Main Control Board (the display board). I ordered the Pressure Sensor and Main Control Board from AppliancePartsPros after checking... Read more

I found that turning the water level switch back and forth would activate the machine So I replaced the water level switch and the plastic hose that connected to it. I purchased a clamp in the purchase, but it was the wrong size! There wasn't a clamp used in the original set up, so I installed the switch and hose without it! It was the video instructions and having the correct parts that made that made this a easy repair! Thank You Read more

I spoke with one of your sales people... ordered the control board and also the button board... ( for $50.00 , I'll replace it too while I'm in there ) .. The boards were here the next day, I installed them and the machine works better than ever ! Easy fix... outstanding sales lady, immediate delivery. Read more

Bought a door light switch from your company and used it to replace the bad one from my stove. Read more

1. Removed the water inlet/shut off valve, removed and cleaned the screen. while the valve was removed applied electrical power to the valve and it worked just fine. 2. replaced the broken float switch. Read more

Replaced the wiring harness Read more

I ordered a new one and replaced it! Read more