Maytag Gasket & Seal

I replaced the old control panel with a new one. I also changed out the door seal to help prevent the control panel from going bad a second time. It was the heat from the oven getting to the keypad on the control panel that caused it to go bad. Read more

Took out the old gaskets put the 2 new ones in and it was all a simple project. Couldn't be easier. Read more

Repair was very easy. No instructions included but basically start the new seal tabs at the bottom in the middle and work your way around snapping in place. 60 seconds Read more

I replaced the gasket that you had sent to me the next day in about 5 minutes! Sears parts direct had the item back ordered and even when I cancelled the order, they still shipped it! I will never use them again! All my appliance part needs will be through Appliance Parts Pros! Read more

I took the dryer apart.....first had to clean out all the lint here and there. Took the drum out, inspected the belt and back support wheels. They seemed to be fine. In the front the drum turns on two supports that have a Teflon glide. Those two glides had been worn off with their pad so metal was rubbing against metal. Went online to appliancepartspros.com and looked up on the schematic what parts I needed. I also had called around locally and the same parts cost twice as much....so I... Read more

Ordered the gasket kit. The shipping time was quick. The installation was more difficult than anticipated. The inside of the door had to be removed there were about 30 hex head screws. the new gasket then had to be fitted to the interior of the door and then placed on the outer part of the door and the screws replaced. The screw replacement took longer than anticipated as there were eight corner screws that were very difficult to manage because of the inside design of the gasket. The screws all... Read more

By myself with my own two hands, a towel, and a screwdriver! I was able to find a video tutorial for how to disassemble my oven. And bonus, I got to do a bang up job on the glass while at, inside and out! As a woman, I was pleasantly surprised at how easy this was. Read more

This was some repair! My SG1000 stackable is over 30 years old and was purchased second hand. I've replaced many parts in the dryer section, but besides a water inlet, this was my first repair to the washer. All of a sudden it started making a terrible noise and was not agitating the clothes. The spin cycle worked fine. I first replaced the two belts on the bottom, but when I removed the old ones I realized they did not look terribly worn and weren't the cause. Many stories on here indicated... Read more

Found the wonderful parts diagrams you most generously share online and a couple of YouTube videos . I determined it should be repairable. In my cast the agitator shaft was frozen (rusted) in place. I was very fortunate to have been able to eventually remove it with the use of a lot of BP penetrating oil and heat. Long and short the replacement parts fit perfectly and the washer is running like new. Special thanks to the online support make my repair possible. Read more

• Oven not heating evenly
• Little to no heat when baking

Ordered oven door seal Part Number Y702338 (Whirlpool AP4291897) to replace the oven door seal on 30-year old Jenn-Air model S125 downdraft slide-in range. I called AppliancePartsPros and confirmed the part number, gathered my courage and asked my son-in-law to help. Thanks to another reviewer's suggestion, we placed a piece of wood about 3/4-inch thick between each of the door hinges and the frame of the oven before removing the door (to hold the hinges open and make it easy to put the door... Read more