Refrigerator Parts

First, I removed the old gaskets, which was a very easy task since they are held in the doors by rubber beads in recessed slots. I installed the new right door gasket in less than 10 minutes by gradually pushing the retainer bead into the door recessed slot with finger pressure until it was seated properly. The left door bead was somewhat more difficult to install into the bead slot, because the recessed bead slot is covered by a hinged flap on its left edge that doesn't permit easy access.... Read more

Replaced freezer door gasket. Door gaskets needed replacement did those as well Read more

Fixing it was extremely easy, I just followed the instructions provided in the AppliancePartsPros video. After getting the part I simply shut off the water to the fridge, unhooked the part's water lines, unclipped the head inside the fridge, installed the new one and reconnected the lines. Took about 15 minutes and likely saved $300 (what a service person would have charged). It was simple. Read more

Ordered new ice maker and installed it (3 screws and plugged in new one) Read more

With the help of AppliancePartsPros.com I was able to find my O.E.M. refrigerator door handle (which has now been discontinued by the refrigerator manufacturer, G.E.) at a much cheaper price than other websites offering either the same discontinued handle or the newer replacement. The door handle kit came with everything I needed to replace my broken refrigerator door handle. I just needed 1 Phillips screw driver for the 2 top screws holding the top of the handle to the refrigerator door and 1... Read more

Replaced the defrost thermostat in freezer and fridge and the defrost heater in freezer. These guys had my parts in stock and I got them in 2 days Read more

1.) Located where the water leak was coming from in the refrigerator. 2.) Unplugged the refrigerator. 3.) Shut off the water supply to the refrigerator. 4.) Unscrewed the back cardboard panel. 5.) Unscrewed the Water Valve attached to the side of the refrigerator (one screw). 6.) Disconnected the three electrical plugs on the water valve. The plugs are different sizes so there is no need to worry about reconnecting incorrectly. 7.) Disconnected the two water lines by pushing down on... Read more

Replaced both The electrical board I found under the fridge was very easy to replace. The fan motor took a minute to bed puns and the biggest challenge was taking off/on the back panel to get to it. (By the way it was located in the freezer section. take drawers out to get to it. Read more

1. Ordered new gasket. 2. Heated with blow dryer gasket until it resumed its normal shape. 3. Turned off refrig. 4. Cleaned freezer compartment. 5. Removed old gasket. 6. Installed new gasket. 7. Turned on refrig. 8, Operation back to normal in about 6 hours. Read more

Ordered left and right side supports and they arrived in two days! It took me longer to get stuff out of the way in the fridge so I could take the shelf out than it did to actually swap out the side supports. Parts fit perfectly and quick easy repair. Read more

Purchased a french door mullion, removed the old one, installed the new one. biggest challenge for me was removing the wires. In retrospect, I should have done a better job of shopping for price. Read more

• Freezer not defrosting
• Fridge too warm

Toughest part of this repair is figuring out how to get things apart. Amana doesn't provide you a repair manual showing how to disengage the various plastic covers. Initially disassembled the bottom freezer compartment so I could get to the evaporator coils; they were completely frozen in block of ice, restricting air flow to the fridge above. Obviously, the auto defrost cycle had not been running, or was short-cycling. Manually defrosted. Found this link for running diagnostic tests on the... Read more

Elderly neighbor charged $100 for factory tech to inform her that the part wasn't available anymore, so I ordered 2 from Appliance Parts Pros.com (one for a spare) and when they arrived a few days later, I installed then in about 20-25 minutes. I had to remove all the food off the door shelf so I could lift the door off the hinge to replace the bushing. That took 5 minutes. Shame on the tech that went by the date of manufacture rather than checks by model and serial number to see if the part... Read more

I ordered a new solenoid valve set and watched the online video of the replacement process. So after emptying my freezer and fridge, removing the doors and freezer drawer, so I could mover the fridge out of its cove, I discovered after taking the panels off the rear, that my fridge is different than that shown in the video. I went back online and discovered in one of the exploded views of the cabinet there is a panel inside the refrigerator which can be removed after taking the shelves out of... Read more

I pried off the old one and plugged in the new one Read more

Ordered part and replace it Read more