Whirlpool Parts

Replaced, took 5 minutes to complete the exchange. Read more

Just pushed it on there Read more

Yes exact fit Read more

I bumped into my KitchenAid dishwasher and the upper rack adjuster cracked. There was already a crack on the notch of the housing where the handle (lever) sits. In addition, the positioner popped out and I couldn't find it. So, I bought the three parts from AppliancePartsPros online. It arrived in about a week. The repair was fairly simple, but it still took about 45 minutes because I didn't want to crack the assemblies. For the housing, use a small slotted screwdriver to carefully... Read more

Watched a quick YouTube video. Read more

I am 72 years old. I appreciate my dishwasher, especially during the Holidays when we have lots of company. The bottom spray arm in my Amana dishwasher was not snapped into place and it ended up on the heating element...needless to say, it fried two holes in the spray arm and from that day on, it did not function as planned. I ordered the part from AppliancePartsPro.com and the new arm arrived as promised. It was well packaged and a perfect fit. I am so pleased and I know when I need parts... Read more

Order parts and replace. When removing attachments, do them one at a time and install them on new rack as you go. Watch for the small release tabs on the attachments (baskets, rollers and tine holders), "gently" put pressure to release; remember these units have been in hot water and they are brittle. Read more

I called a repairman and he wanted $230 to put in a new timer so I went online to Appliance Parts Pros.com and found the part and watched video on how to replace timer. The timer cost $89 and I received it in 2 days. It took about 3 minutes to replace and my dryer works great! Read more

Rebalanced the load but noticed the drum was sitting lower and the springs were wore out and it went out of balance easy, so i got the suspension rod kit and installed it and it works much better. It took me 2 hours because i didnt have adequate room to move around. Hour job if you have room. Read more

Removed old nob and replaced with new one. Read more

Replaced lower door seal assy. Easy job even with a bad back. Read more

• Element will not heat

Followed the instructions that came with the replacement part: made sure stove top was unpowered, unscrewed the old housing from the stove top, cut the wires, stripped some insulation off, attached the new wires with the (accompanying) wire nuts, attached new housing to stove top. Read more

Replaced lid and hinges. Read more

Ordered new insulation from AppliancePartsPros. It was delivered quickly and easy to install. Read more

Put in new LED lighrt module you sent me Read more

I think I could have just replaced the pump, but I chose to replace the whole assembly. The part is more expensive, but all the gaskets, etc, that come with it are new and that made sense to change all at once. I was able to change this in about 30 minutes, without removing the washer from the under-counter space. I did remove the front door panel, but in retrospect that was unnecessary and probably cost me more time than it saved. Empty the washer of parts, remove the front access panel.... Read more