Amana Gasket & Seal

I tried unsuccessfully to find the model numbers for these two appliances until I called your company and your representative found them immediately and sent me the parts I think that the same day or the next day. Instructions were clear and easy and I installed them within moments, neither one was any trouble. Read more

I took the dryer apart.....first had to clean out all the lint here and there. Took the drum out, inspected the belt and back support wheels. They seemed to be fine. In the front the drum turns on two supports that have a Teflon glide. Those two glides had been worn off with their pad so metal was rubbing against metal. Went online to appliancepartspros.com and looked up on the schematic what parts I needed. I also had called around locally and the same parts cost twice as much....so I... Read more

• Door sweating
• Fridge runs too long

I used the Company's chat line on 11/18/2015 to speak with a representative to make sure I would be ordering the correct replacement part. That was a very helpful and pleasant experience. The agent assured me I would be receiving the part within two days and she was spot on. She indicated I would be receiving an Order Confirmation email with a link to a repair video. The video was very helpful in describing the process to remove the old gasket and the tools I would need. I installed the... Read more

I replaced the gasket Read more

Instructions are very dumb, but it's an easy fix. Loosen all the nuts that hold the metal bars that hold the old gasket. (Loosen. Don't take them off!) Pull off the old gasket. Slip the new into place all the way around. Get the corners in position, middles can be loose. Tighten the corners, then work the middles into place and tighten as you go. Done. Read more

I purchased a freezer gasket + key// from appliancepartspros.com //easy to order. I did not need to lock up my freezer but thought it might help the gasket seat (good thought). To replace gasket I started at top of door, wow, I should have started at bottom. Hated laying on my "belly" to screw in gasket. Ok, I am 77 years old but got the job done. All went okay until I had to close the door, the door would not stay shut. Key: I locked the door for a week. New seal is settling in, freezer is... Read more

Bought gasket from website, followed easy helpful video instructions, perfect fit. Read more

With the basket out of the dishwasher, the plastic parts basically snap on and off... popped the broken parts off and the new parts on. The 2 wheel and mount assemblies were a little more complicated. The video on the website advises to disconnect the supply line and drain line... I didn't have to do this. I just pulled the dishwasher out of its cabinet a little over a foot and removed the 2 screws holding each assembly in place and removed them. The previous gaskets (2 PER ASSEMBLY)... Read more

• Door sweating

Ordered new door seals (gaskets) from Appliance Parts Pros. I was able to replace the freezer door seal without taking the door off the refrigerator. (Note: this is an over/under type refrigerator, with the freezer section on top) However, the first attempt at replacing the refrigerator door seal without removing the door from the fridge did not go well as the door appeared "warped" after I reassembled it and would not come close to sealing when I closed it. When I took the door off the fridge... Read more

Removed old gasket from groove then pushed new one into the cleaned groove. Took 5 minutes. Read more

• Freezer section too warm

I ordered the replacement gasket and...replaced it. One issue was that the replacement procedure was not at all like the video to which I was directed when I got the gasket. The video showed a gasket with a rigid flange that had to be inserted into the door structure. On my Amana, I clearly had to remove the inner plastic liner and set the gasket under it. This was not particularly difficult but certainly wasn't the same process. Also, I removed the freezer door to do the replacement in... Read more

The root cause was the front glides. They were virtually gone, and the drum was on metal to metal. So I replaced them with a front glide kit. I also replaced the belt, rear rollers, and lint screen. I am happy to say all the parts fit perfectly, and I couldn't find a better price anywhere else. I will definitely keep you on file for the next time I need appliance parts! Thank you! Sincerely, pw Read more

• Door sweating
• Fridge runs too long

Loosened nuts around outer flange. Pulled out old gasket as shown in video. Prepared new gasket per included instructions. Installed new gasket again using techniques shown in video. Secured nuts then confirmed proper seal. This was not a difficult repair however patience and care is needed to ensure new gasket is properly seated without damage. Read more

Repair was very easy. No instructions included but basically start the new seal tabs at the bottom in the middle and work your way around snapping in place. 60 seconds Read more

Really simple fix no tools required. Simply pulled the old out and install the new one in . Not hard at all. Read more