Electrolux Gasket & Seal

Cooktop burner gasket seals the burner assembly to prevent gas leaks and ensure proper combustion. Replace if worn, cracked, or causing uneven flames. Verify fit with your model number before ordering.

Replace your range oven door seal to maintain heat efficiency and prevent energy loss. Essential when you notice gaps, cracks, or heat escaping. Verify fit.

This door gasket seals the refrigerator door to help maintain proper temperature and energy efficiency by preventing warm air from entering the cabinet. It replaces a worn or torn seal to restore a tight closing perimeter. What it does:

• Creates an airtight seal around the refrigerator door to help keep cold air in and warm air out.
• Helps reduce frost buildup and keeps food at consistent temperatures.
• Commonly replaces gaskets that are cracked, flattened, torn, or no longer form a tight seal.
• Can reduce excessive compressor run time and cycling caused by air leaks.

• One refrigerator door gasket.

• High-level DIY replacement: remove the old gasket, clean the door flange, and press the new gasket into the retainer channel; some gaskets may require slight heating to set the fit.
• Check alignment and ensure gasket fully seats around the door perimeter before testing.
• Use basic hand tools; disconnect power if working near electrical components or lighting.

This door gasket is a direct-fit replacement seal for your refrigerator door that helps maintain an even internal temperature and reduces air leaks and moisture intrusion for better cooling efficiency. What it does:

• Forms a tight seal around the refrigerator door to limit warm air entry
• Helps reduce frost and moisture buildup by keeping humidity out
• Supports consistent cooling and efficient compressor cycles
• Minimizes energy loss caused by a compromised door seal

• High-level swap: remove the old gasket by loosening retaining screws/clips, seat the new gasket into the channel, and retighten hardware as needed
• Warm the gasket (hair dryer or hot water) if needed to flex and fit corners smoothly
• Inspect the door flange and magnetic strip for damage before reinstalling
• Always unplug the appliance or shut off power before performing repairs

Microwave door seal creates airtight closure for safe operation. Replace if torn, cracked, or loose to prevent microwave leaks. Verify fit with your model.

Adhesive seal tape restores tight door seals on ovens, reducing air leaks and improving temperature control. Replace when worn or damaged. Confirm fit.

This replacement door gasket seals the refrigerator door to help maintain proper cooling and reduce air leaks. It restores a tight seal to help prevent temperature fluctuations and excess energy use. What it does:

• Forms an airtight seal around the refrigerator door to keep cold air inside
• Helps reduce frost buildup and warm spots caused by a failing seal
• Can improve cooling consistency and reduce compressor run-time when worn gaskets are replaced
• Fits into the door channel and compresses to close gaps between the door and cabinet

• Disconnect power to the appliance before starting any work
• Clean the door channel thoroughly and remove old gasket before installing the new one
• Warm the gasket to improve flexibility for easier installation; avoid open flames or high-heat tools
• Press gasket fully into the channel and check for even compression around the entire door; trim only if the manufacturer explicitly states trimming is required

This return air seal keeps refrigerator airflow channels sealed so cold air returns to the evaporator properly, helping maintain consistent temperatures and reduce frost and moisture issues. It replaces a worn or damaged return-air gasket. What it does

• Seals the return-air opening to direct cold air back to the evaporator
• Helps maintain even cooling and prevents warm air infiltration
• Reduces frost, moisture buildup, and uneven temperature zones
• Commonly replaced when you notice poor cooling, excessive frost, or air leakage noises

• One return air seal

• Disconnect power before starting work
• Remove any trim or panels that block access to the return-air opening
• Seat the seal into the channel or mating surface; some installations use adhesive or retainers—follow the manufacturer's instructions