Frigidaire Touch Pad

Replace a cracked, worn, or unresponsive touch pad control panel on your room air conditioner. Installs on the front control interface assembly.

Replacement touch pad overlay for room air conditioners. Installs on the control panel. Order when your original overlay is cracked, peeling, or worn.

Replace your air conditioner's touch pad control panel if buttons are cracked, unresponsive, or worn. Restores control interface functionality.

Touch pad control panel for air conditioners. Replaces cracked, broken, or unresponsive control panels. Mounts on the front of the unit housing.

Fix an unresponsive or cracked dispenser touchpad with this refrigerator control panel. Restores water and ice dispenser button functionality.

Replace the touch pad membrane on your range control panel. This part covers worn, cracked, or unresponsive button areas on the interface overlay.

Touch pad control panel for air conditioners. Replaces cracked, worn, or unresponsive touch pads on the unit's display interface. Direct fit part.

Replacement touch pad control panel for air conditioners. Installs on the front control interface. Order when original pad is cracked, unresponsive, or worn.

This is the electronic control board that governs the appliance's cooling system. It interprets sensor input and user settings to run key components, helping maintain consistent temperatures when the original controller becomes faulty or erratic.

• Monitors temperature sensor feedback and executes cooling cycles to hold the selected setpoint
• Controls major components on applicable models
• May manage additional functions like defrost timing or alarms depending on model design
• Failure can present as warm or unstable temperatures, unit not starting, short-cycling/running constantly, or unresponsive temperature adjustments

• Disconnect power before service; observe ESD precautions and handle the board by its edges
• Note wire/plug locations; transfer connectors to the new board one at a time
• Secure the board in its mounting and ensure all harnesses are fully seated
• Reassemble covers/panels before restoring power and checking operation