General Electric Door Stop Or Cam Riser

White freezer door stop that holds the door in place and prevents it from swinging too far. Replaces cracked, broken, or missing door stops.

Refrigerator freezer door stop that prevents the door from opening too far. Replace if your original stop is cracked, broken, or missing.

Door stop component that prevents your refrigerator door from swinging too far open. Replace this part if broken, cracked, or missing to restore proper door control.

This cam closure is the left-side closing cam that secures and aligns the freezer door, helping the door latch properly and maintain an even seal to keep the compartment cold. A direct-fit replacement that restores proper door action. What it does:

• Guides and locks the freezer door into the correct closed position
• Helps maintain an even door seal to reduce cold air loss and frost buildup
• Prevents door sagging or misalignment that can keep the door from latching
• Works with the door hinge/latch mechanism to ensure smooth opening and closing

• Disconnect power to the appliance before starting any repair
• Installation may require removing the freezer door or inner door panel; keep fasteners organized
• Handle plastic components carefully to avoid cracking; align cam to hinge before tightening

This cam closure secures the freezer door hinge, helping the door align and latch properly to maintain a tight seal and consistent temperatures. It replaces a worn or broken left-side cam closure to restore normal door movement. What it does:

• Guides and supports the freezer door hinge so the door closes and opens smoothly
• Helps maintain a proper door seal to prevent cold air loss and uneven cooling
• Replaces a broken, cracked, or excessively worn cam that causes door sag or misalignment
• Works with the hinge assembly to keep the door correctly positioned during use

• Disconnect power (unplug or switch off breaker) before starting repairs.
• Remove the freezer door or hinge trim as needed to access the cam; keep fasteners organized.
• Inspect hinge and surrounding components for wear; replace additional damaged parts as required.