Kenmore / Sears Gasket & Seal

• Freezer section too warm

New gaskets. from appliance parts pros Read more

Ordered boot, nozzle, and inner spring for boot. Would have ordered outer, but the schematic for parts made it very difficult to navigate to locate parts...24 hr/next day air and I have a happy wife. The only thing that would have made it easier, was having a pair of Spring Expansion pliers, be careful not to pinch inner boot! Used Youtube video as a walk through, completed in the fraction of the time if i hadnt watched! Read more

• Marks left on clothes

1) I spent a half-day researching online for possible causes for squeaks. Discovered the AppliancePartsPros YouTube videos, which were the best I found for clarity and ease of understanding. 2) I went from the videos to the website to locate each model-specific part that might have been causing the noise. Once I identified the parts for my model of dryer, I called customer service to confirm that I had the right ones before placing my order. I spoke with Sharon, who was very helpful and... Read more

• Frost buildup

Arrived on time and was a good fit. no problems at all thank you Read more

Ordered new one online. It came in 2 days with instructions. I installed it and works great. Read more

• Door sweating

My co-worker bought a house to flip and gave me the refrigerator. I'd been looking for a garage refrigerator to store water, cola, etc in. Fridge was essentially fine but I sanded and painted one side which had rust spots. Turned out like new. The door seal was moldy and didn't seal properly. The only advice I can lend is to take the door off the hinges and lay it down flat. So much easier. With this seal you basically just take out all the screws, peel off old seal and set the new one... Read more

Fairly simple fix. followed you tube video step by step..needed a set of extra hands (wife came in handy) when installing gasket..after several loads as a test, no leaks. Read more

Removed old bellow following procedures found on relevant Youtube videos. Reinstalling however was more of a challenge. Getting the rear seal of the new bellow on the washer housing was not as easy as the videos indicated. The key to that process is being sure the seal is well lubricated which is not quite apparent from the videos but is essential success. Once the rear seal is installed, reapplying the rear spring was accomplished with the spring clamps as per the videos. Be sure to... Read more

Bought this door gasket and watched the video, very easy if you just take your time and start in one corner and go to the opposite corner. this way it stretches the seal completely into each corner. do as the video says and it will go great. Read more

Ordered and installed replacement seal Read more

• Takes too long to dry

Get some acetone at a Hardware Store before you start. A pint will do. Unplug the dryer from 110 VAC. Pull the top off of the dryer, by lifting it from the front first. It is attached with snap metal fittings. Do not completely remove the top, just tip upright to gain access to the front interior of the dryer. Before you pull any wires from the door switch, record which color wires go to which terminals on the door switch. If you reassemble the connections incorrectly, the gas value will... Read more

I look on the internet i came a cross appliance parts pros i didnt no what i was looking for so i call the phone number talk to someone gave him the info he ask for they has what i was looking for in stock the guy was very nice he say i will get the part in two days and i got it in two days if i need a part for anything else i will ckeck out appliance parts pros when the door gasket came my grandson put it on in a flash Read more

Purchased seals from appliance parts pros and watched videos to replace. The website and videos made the install a breeze. I am a huge fan of your website and videos. I have used them for years to fix all sorts of home appliances. Read more

I took the new seal out of it's packaging and used a blowdryer on low heat to soften up the seal so that the crease from shipping (it was folded to ship) disappeared. Next I took the refrigerator door off, removed the old seal, & cleaned the area where the new seal would be applied. Following the video on the Appliance Pro Parts website, I re-installed the new seal and put the door back on. Last step was to snap on the new hinge cap I ordered. The video online was easy to follow and this... Read more

Removed front panel from refrigerator door and replaced the ice chute door seal and also replaced the seal inside the door that seals against the ice maker. Read more

Took the whole dryer apart to access the wheels (4) of them, belt and fan wheel, also had to clean all the lint out that somehow builds up inside the dryer. Plus cleaned out dryer duct vent, added to the time involved. If you are planning on fixing the dryer because of a noise which was in my case, I highly recommend buy all the parts for complete maintenance mentioned above. What helped save me time? I watch a dryer fan wheel replacement training video first, highly recommend this!... Read more