Kenmore / Sears Valve

• Ice maker not making ice
• Leaking

Order new valve Read more

I replaced the old water valve with the one ordered and the problem was resolved. Read more

Fridge is 14 years old, ordered the water valve assembly and hose. Removed and replaced both Read more

REPLACED BACKFLOW CHECK VALVE DIAPRHAM & PUMP Read more

Super simple project that cost 110. My stackable washer is back in action. Read more

Replacing the upper nozzle connector did the trick. I could not see damage in the older upper nozzle, it is possible that I could have fixed this just by tightening the parts - but i am happy I purchased both the upper nozzle and check valve ball, it feels good to have installed brand new parts in the washer. Read more

• Will not fill with water

Took the washer out, turned it over and found the solenoid that worked the drain valve to be melted, and the shaft that the solenoid activates was heavily corroded. I found the right parts on your website after reading the notes left by other customers, then watched the video. The repairs were fairly simple and successful. This was a GE profile dishwasher. Read more

First determined drain discharge hose was clear. Turned of power to dishwasher. I did not find it necessary to remove the dishwasher. I simply removed the lower service panel at the floor and was able to easily remove the defective pump, unplug it, replace the small rubber check valve flapper before the pump inlet and reinstall the new pump assembly. The dishwasher surprisingly cleans and runs quietly like new again although I found no excuse for the pump failure as it is well designed. Never... Read more

• No hot or cold water

I order the part from appliance parts recieed it in one day and it was repaired the next day so simple watched video thanks to you all is well i highly recommend you to anyone barbara mcallister Read more

Ordered both the sets of water valve because both had failed. The ice maker valve failed intially which I ingnored for probably 8months. Then the main failed so no water was getting to the water dispensor. Replacing both sets of solinod valves take about 20minutes Read more

Researched, then decided to try everything suggested. Cleaned the hidden filter under the washer, checked the lines and the water inlet valves, opened it up and found a hose rubbed thin because it wasn't clipped correctly during the manufacturing process. Replaced the inlet valve, pressure sensor and the thinned tube (all parts except the hose from appliance parts pros.com-had to get the hose at the car parts store). Machine has not worked this well in years, and saved hundreds in labor. Your... Read more

Took the old one out and replace it with the new one. Read more

Replaced the water inlet valve. Read more

Replaced both primary and secondary water valves to make sure I fixed the problem. Both valves have to open when you function the water dispenser and when the ice maker tray needs refilling. YouTube video was a great help and let me know that I had to lengthen one hose. The video showed me the exact parts I needed to lengthen the hose. YouTube video also let me know that I had needed to transfer the internal springs in the hoses when I cut the old connections off. Never would have known... Read more

Ordered new circuit board and water pump. Hired a professional to install them Read more