Kitchenaid Gasket & Seal

Ice chute door gasket seals the ice compartment opening on your refrigerator. Replace if ice melts prematurely or warm air enters. Confirm fit with your model.

Seals your oven door to retain heat and moisture for even baking. Replace when worn, cracked, or causing heat loss. Verify fit with your model number.

Seals your freezer door to maintain cold temperatures and prevent frost buildup. Replace when worn or damaged to restore efficiency. Verify fit with your model.

Replace your food processor bowl seal when you notice leaking or decreased performance. Ensures tight seal between bowl and base. Verify fit with model number.

Replace your gas range oven door gasket to restore proper heat seal and improve cooking efficiency. Verify fit with your model number before ordering.

Replace your refrigerator freezer door gasket to restore the seal and prevent frost buildup. Installs in minutes—press into door liner. Confirm fit by model.

Seals the rear of the dryer drum to prevent hot air loss and ensure even drying. Replace when worn, cracked, or causing noise. Verify fit by model.

Seals your refrigerator door to maintain cooling efficiency and prevent warm air entry. Replace if torn, cracked, or not sealing properly. Confirm fit with your model number.

Seals the fresh food door to prevent air leaks, reduce condensation, and maintain temperature. Replace when cracked or loose. Confirm fit with your model.

Freezer Door Gasket

Prevents heat transfer around oven door glass. Replace if worn, loose, or expanding out of position during heating. Confirm fit with your model number.

Replacement gasket that restores a watertight seal at the factory connection to help prevent leaks and protect floors and cabinetry from water damage. Use to replace cracked, hardened, or torn seals. What it does:

• Seals mating surfaces to stop water leakage and reduce moisture-related damage.
• Common symptoms it helps address: visible leaks, pooled water under the appliance, or degraded/rubbery gasket material.
• Replaces worn, cracked, stiff, or torn seals to restore proper sealing performance.
• Seats into the original gasket groove—ensure the seal is fully seated with no gaps.

• Disconnect power and water supply before starting any service.
• Remove the old gasket, then clean and dry the mating surfaces and gasket groove.
• Press the new gasket into the groove evenly and inspect for full engagement around the perimeter.
• Restore power/water and run a short test cycle; check thoroughly for leaks before returning the appliance to regular use.