Maytag Heating Element

Replaced the heating element and we have heat to dry our cloths THANKS Read more

• Little to no heat when broiling
• Element will not heat

Turned off breaker to oven, took pictures of existing broil, supporting bracket and shield attached to oven, removed screws holding element, support piece and shield, removed bracket and shield, pulled out the element, took another close-up picture of the wires connected to element, removed wires, connected new element, turned breaker on to see if connection is correct, turned it off, installed element, shield and support bracket (in this order). Turned breaker on. Hardest part was loosening... Read more

I figured there could only be a couple reasons why the dryer would not heat so I did some research. I read where you could test for continuity on the parts to determine which one was bad. A friend referred me to this site, I looked up the part for my particular model, ordered and replaced the part. It could not have been any easier. I will come back to this site with my future appliance parts needs for sure! Read more

• Element will not heat

Purchased a new Element surface and installed same... All Okay now... Read more

• Little to no heat when broiling

Ordered a new one. Read more

• Little to no heat when broiling

I wanted to get the upper oven baking element replaced; it hasn't been working for a few months. This double oven has had two other issues, there is a fan that comes on to cool the electronics panel, That fan has made excessive noise and it operates for 2-3 hours after the oven turns off. The other problem with the oven is the Self-Cleaning feature runs for about 15-30 minutes and then turns off with an error code. I've had a local appliance repair person in to address the error code and... Read more

Little procrastination paid off. With only 50% capability I knew it is time to call the appliancepartspros. They shipped me parts within 3 days. It was practical to fix both at the time. All I needed was to disconnect power at range breaker box, grab a screwdriver to lift top open, a 16 inch or so piece of old 2×4 wood to keep the top top of stove lifted, so I could access heating elements from underneath. Then I took my black sharpie And marked location of mounting screws and... Read more

Watched your video and followed the instructions. It was a quick and easy fix. Thanks Appliance Pros and the delivery took less than 48 hours, that was standard shipping. I will order from them again when I need parts ! Thanks Read more

• Little to no heat when baking

It took 10 minutes and a screwdriver, remember to turn off power to the oven at the fuse box. By the way, I ordered the part at 1:30pm and received it at 12:30pm the next day using normal shipping, not bad. Read more

Replaced the fuse resistor and the heating element. Read more

First, watched a how to you tube video. Then, proceeded to repair my stove. Read more

I purchased the replacement element. The element was a direct replacement. The entire replacement took 20 minutes, 15 minutes of which was to clean the range before putting it back. Read more

• Little to no heat when baking

The delivery of the element was superfast, less than 24 hrs. Unplug the Stove from the receptical! Took a phippips screwdriver and took out the 2 screws holding it, and tilted it upwards a bit and pulled the element out about 3 inches an unhooked the wires. Hooked the wires up to the new element and pushed it back into the holes and put the 2 screws back in and turned the stove on and that was all there was to that. Read more

We got the heater core kit. Unplug, undo two screws and pulled old one out. Looking at the old one, put the new one together and then mounted it back in place. Turned on dryer but no heat so unplugged it, tapped on elements, plugged back in and it worked. Not to hard. Read more