Refrigerator Parts

No instructions are included with either piece, which makes installation take more time and care. Tools needed: Small standard flat blade screwdriver, box knife or other knife with at least a 2" long blade, super glue. Remove the old main crisper frame: 1. Remove old main frame by lifting upward and outward. 2. Remove the center rail from the frame. May require bending of the main frame to remove it. 3. Remove the crisper front panel by unsnapping from frame. This is easily done by... Read more

Very easy to replace, two screws and two connectors on the board. Read more

Just wanted to say how incredibly nice and helpful the gentleman was that helped me on the phone when I called to place the order. Very nice..... Read more

First I verified there was good water volume getting to the door, by uncoupling the hose at the door bottom (press in coupler ring) and activating the dispenser, there was not. (have a cup ready) Since the water filter is inline, and I had another I subbed it. Still no change. Here I made an error. I verified the water supply was fine, so jumped to the conclusion it had to be the solenoid operated valve, which it was not. I did not realize that the water filter bracket it attaches to has it's... Read more

I wasn't sure if it was the door being warped, the spring return being worn, or the rotary damper failing, so I ordered all to update the door mechanism. I also ordered a new micro switch since one of the switches had started to require more and more pressure to actuate. Figured I'd fix it at the same time. Repair was very straightforward and the videos available on this and other repair sites were very helpful. I found a video that showed replacing the door mechanism on a nearly identical... Read more

After watching several YouTube videos on similar problem, I decided to replaced the air diffuser. Read more

Based on my model # and serial # the Appliance Parts Pros were able to quickly find and ship the gaskets I needed. The instructional videos showed me how to remove the old and replace with the new. I was able to easily do it myself. Read more

Purchased new gasket from your site. Watched the video for how to change it.Took about 15 min. to remove the old one and install the new one. Read more

First, I removed the old gaskets, which was a very easy task since they are held in the doors by rubber beads in recessed slots. I installed the new right door gasket in less than 10 minutes by gradually pushing the retainer bead into the door recessed slot with finger pressure until it was seated properly. The left door bead was somewhat more difficult to install into the bead slot, because the recessed bead slot is covered by a hinged flap on its left edge that doesn't permit easy access.... Read more

There are five LED's in the ceiling and two along each side of the refrigerator compartment and one in the freezing compartment of which (throughout my ownership of my French-door KitchenAid refrigerator) I've replaced three. The LED's are wired in series (akin unto old-time Christmas tree lights), such that when one goes out, all in that circuit are also out. The freezing compartment light is on a circuit with the two along each side of the refrigerator compartment, so that when it... Read more

Removed the back cover to access the fan area. Clean the area with brush and vac first. Unplugged the Refrigerator. Used a socket set with 1/4" socket. Had an extended and a standard socket. Removed the condensate plastic drain from the bottom of the refrigerator to have more access to the fan. Unplugged the fan motor. Removed the two screws holding the fan in place. Removed the fan unit from the condenser side of the bracket. Place new fan on the fan and installed exactly the way I removed the... Read more

Our refrigerator takes care of my wife and I, along with our children when they visit, and the grand kids. Over the years, it's seen its fair share of wear and tear. Thankfully, nothing major has happened that hasn't been able to be repaired right here in the home, and by me. Our refrigerator is a GE side-by-side with an ice maker/water dispenser, and has held up well. I've ordered parts for it from AppliancePartsPros.com for all of its repairs, and while GE/Frigidaire have been changing out a... Read more

Ordered part, the correct part came the next day. Read more

• Noisy
• Freezer section too warm
• Fridge too warm

Replace evaporator fan motor located in freezer compartment Read more

Replaced broken handle support bracket (part #AP5620448) and cap (part #AP5620751). Used a phillips head screwdriver and allen wrench. Pliers also came in very handy. If replacing cap and support bracket, be sure to install cap before support bracket, otherwise you'll have trouble installing the cap. I ended up not needing to replace the fixer handle (part #AP4372038), but I'll keep it around just in case. Read more

Having never fixed a fridge before, I did a little research. The unit was not old & the cooling system was operating. Observing the frozen ice inside, I diagnosed it as the heat rod and/or it's thermostat as bad. I contacted ApplianceParts Pros, who assisted in confirming my theory. IMPORTANT NOTE: the sales advisor Joyce was truly an intelligent, knowledgable professional, NOT some "burger-order taker" usually encountered. This alone speaks VOLUMES. Subsequently, the parts arrived... Read more