Screws, Nuts, Washers

Genuine Ge part

Washer (Flat Metal)

By: Ge

Part Number: WH02X10205

This flat metal washer provides a simple, durable spacer or load distributor for fasteners on select GE clothes washers. It helps maintain secure connections and proper spacing to prevent loosening and uneven loading during operation. What it does

Distributes bolt or screw pressure to protect mating surfaces and prevent pull-through
Maintains correct spacing and alignment for assemblies that use small fasteners
Helps reduce loosening from vibration that can cause noise or misalignment
Commonly used where a thin, durable washer is needed in washer assemblies

What's included One flat metal washer Install notes

Disconnect power and unplug the appliance before starting any repairs
Turn off water supply when working near water lines or tub assemblies
Use the correct size fastener and torque to avoid over-compressing the washer
Inspect mating parts for damage and replace any worn hardware to ensure a secure repair

$7.37

Compare At:: $8.36
You Save:: $0.99

IN STOCK

Ships Tomorrow Guaranteed

Add to Cart

Genuine Ge part

Bolt M8 48

By: Ge

Part Number: WH02X10207

$18.95

Compare At:: $22.74
You Save:: $3.79

IN STOCK

Ships Tomorrow Guaranteed

Add to Cart

Genuine Ge part

Bolt 8X58

By: Ge

Part Number: WH02X10216

$16.54

Compare At:: $23.39
You Save:: $6.85

IN STOCK

Ships Tomorrow Guaranteed

Add to Cart

Genuine Ge part

Scr 8-16 B Flp .625 Z (Power Control)

By: Ge

Part Number: WH02X10217

This silicon controlled rectifier (SCR) is a replacement power-control semiconductor that helps regulate current to heating and motor circuits, restoring proper cycling and output in affected appliances. What it does:

Controls and switches power to heating elements or motors by gating current flow
Helps the appliance regulate temperature or motor speed when functioning correctly
A failing SCR can cause no heat, intermittent heating, or erratic motor behavior
Designed to mount to a flange with a .625-inch tab for electrical connection

What's included: One SCR power-control module Install notes:

Always disconnect power at the breaker or unplug the appliance before servicing
Handle the SCR by its edges; avoid touching terminals and observe ESD precautions when possible
Verify proper orientation and secure mounting to the heatsink or chassis per the service manual

$7.37