Washer Hose Or Tube

Bleach dispenser hose for washers. Connects the bleach dispenser to the drum. Replace if cracked, leaking, or disconnected to restore proper dispensing.

This replacement hose restores proper water flow and transfer in compatible Frigidaire appliances, preventing leaks and maintaining reliable operation. It's a direct-fit component designed to replace worn, cracked, or leaking hoses. What it does

• Carries water between components to enable normal appliance operation
• Helps stop leaks caused by cracked, split, or degraded hose material
• Supports steady water flow to prevent poor performance or error conditions
• Fits into existing hose connections without changes to plumbing

• Hose

• Turn off power and water supply before starting any repair
• Inspect connection ends and clamps for corrosion or damage; replace if needed
• Push hose fully onto fittings and secure with the correct clamp type and tightness

Replace your washer's inlet hose if cracked, leaking, or worn. This hose connects the water supply to your washer. Essential when the original is damaged.

This 4-foot rubber fill hose replaces the flexible water fill line that supplies water to the ice maker/dispensing system. It restores a secure, leak-resistant path for water so the ice maker can fill properly. What it does:

• Carries water from the household supply to the ice maker/fill cup
• Replaces cracked, brittle, or collapsed tubing that causes leaks or poor fill
• Helps stop intermittent or continuous water leaks at the fill connection
• Restores proper water delivery so ice production and dispenser filling work normally

• Turn off the water supply and unplug the appliance before replacing the hose
• Remove old hose and hose clamps; install new hose fully over fittings and secure with clamps
• Check all connections for leaks after restoring water and power
• Do not kink or sharply bend the hose; route to avoid rubbing on sharp edges

Washer vent pipe that connects to the tub or drain system. Replace this tube if cracked, kinked, or leaking to restore proper drainage and ventilation.

Replace a cracked, broken, or missing washer vent pipe. Installs at the top rear of the washer tub to allow proper air circulation during wash cycles.