Washer Hose Or Tube

This replacement hose supplies water to your appliance to restore proper flow and prevent leaks. Use it when the original line is cracked, brittle, or leaking to re-establish a secure water connection. What it does:

• Carries water between appliance components to enable normal operation
• Replaces hoses that leak, are cracked, split, or collapsed
• Helps restore proper water fill and flow when low/no water is caused by a damaged hose
• Prevents water damage by providing a secure, intact water pathway

• One replacement hose

• Turn off water supply and unplug the appliance before starting any repair
• Inspect connection ends and replace or reuse clamps as needed for a secure fit
• Avoid sharp bends or kinks; route hose according to the appliance's original path

This drain hose carries wastewater away from the appliance so it can drain properly and avoid leaks or standing water. It restores proper water flow and helps prevent spills and floor damage when functioning. What it does:

• Routes wastewater from the appliance to the household drain or pump
• Enables normal drain cycles and prevents water from backing up
• Helps stop leaks and puddling caused by damaged or disconnected hoses
• Common symptom: visible leaks, poor or slow draining, or water on the floor

• One drain hose

• Disconnect power and turn off the water supply before beginning any repair
• Inspect hose ends and clamps; replace clamps if corroded or damaged
• Ensure hose is routed without kinks and secured to the drain or pump to prevent leaks
• Test the appliance through a full drain cycle after installation and check for leaks

This U-shape drain hose hanger secures the dishwasher drain hose to the cabinet or sink rim so the hose stays in the correct position and helps prevent kinks or improper drainage. A simple replacement that restores proper hose routing. What it does

• Holds the drain hose in a U-shaped loop to maintain proper high-loop or air gap positioning
• Keeps the hose away from sharp edges and hot components to reduce wear
• Helps prevent hose kinking that can cause slow draining or backups
• Useful when existing hanger is cracked, broken, or missing

• One U-shape drain hose hanger

• Turn off power to the appliance before accessing the drain hose area
• Typically installs by clipping or snapping around the hose and attaching to cabinet/sink edge—no special tools required
• Inspect the hose for damage and secure hose routing when replacing the hanger

This hose inlet directs hot water into the appliance and replaces a worn or cracked inlet to restore proper water flow and reduce leaks. It's a direct-fit service part used on compatible GE laundry appliances. What it does

• Provides the hot-water connection point for the appliance's fill valve and water supply hose
• Restores a secure, leak-free inlet when original housing is cracked, split, or damaged
• Helps stop intermittent filling or visible leaks at the water hookup
• Matches OEM fit and mounting locations for straightforward replacement

• Turn off water supply and unplug the appliance before starting work
• Drain remaining water from inlet lines to avoid spills
• Inspect hoses, seals, and fittings; replace damaged components and use thread sealant or new gaskets as specified by the OEM