Washer Leg Or Foot

Replacement roller wheel for your washer. Installs on the base to allow smooth movement. Order now if your wheel is cracked, broken, or missing.

Rear leg assembly for washers. Replaces broken, cracked, or worn rear leveling legs that affect machine stability and balance during operation.

This left-side level leg assembly provides an adjustable support to stabilize and level your appliance for safe, wobble-free operation. Durable construction restores proper height and helps prevent tipping or uneven loads. What it does:

• Replaces a worn or damaged left leveling leg assembly to restore stable support.
• Allows height adjustment to level the appliance on uneven floors.
• Helps reduce vibration, rocking, and noise caused by uneven footing.
• Supports safe operation and proper door alignment where applicable.

• One left-side level leg assembly

• Requires basic hand tools; your appliance manual for access steps.
• Adjust height with the appliance in the intended location; ensure power is off and the appliance is secure before working.
• If lifting the appliance is needed, use safe lifting techniques or get help to avoid injury.
• Left/right orientation matches your appliance before installation.

This right-side leveling leg assembly replaces a worn or damaged support leg to stabilize and level the appliance for proper door alignment and operation. It restores a steady foundation so doors close evenly and the unit sits flush on the floor. What it does:

• Provides adjustable support to raise or lower the right front corner of the appliance
• Helps stop rocking, wobbling, or uneven sit when floor surfaces are irregular
• Restores correct door alignment and sealing when tilt causes gaps
• Transfers cabinet weight to the floor for stable operation

• One right-side leveling leg assembly

• Disconnect power (and water if applicable) and remove food/items from doors before working near the appliance
• Support the appliance with a jack or help to safely relieve weight while replacing the leg
• Thread the leg in or out with hand or wrench to adjust height; make small adjustments and re-check level
• Do not overtighten; ensure secure fit and stable contact with the floor