Washer Leg Or Foot

Self leveling leg pad

This replacement rubber foot cushions the machine's contact point with the floor to improve stability, reduce vibration, and protect surfaces. Replace a worn or missing foot to restore steadier, quieter operation and easier leveling.

• Provides a cushioned, non-slip contact point between the appliance and floor
• Helps absorb vibration and reduce rattling or movement during cycles
• Aids in proper leveling and overall stability
• Replace when cracked, flattened, or missing, or if the unit rocks or "walks"

• Disconnect power; for washers, also turn off water. If applicable, shut off gas supply
• Carefully tilt or raise the appliance with assistance and proper lifting support
• Remove the worn foot and install the new foot on the leveling leg or base as designed, ensuring it seats fully
• Re-level the appliance and tighten any locknuts; verify stable operation

2 included - Front load

This foot pad cushions and supports an appliance leg to reduce vibration and protect flooring. It helps stabilize and level the unit for quieter operation and prevents metal-to-floor contact that can cause scratches or noise. What it does:

• Cushions the appliance leg to absorb vibration and reduce noise
• Helps stabilize and level the appliance to prevent rocking or tilting
• Protects hard floors and finishes from scuffs and scratches
• Can reduce movement that contributes to rattling or squeaking during operation

• Disconnect power and water and follow appliance safety procedures before working underneath the unit
• Raise or tilt the appliance only as recommended by the manufacturer; use a helper or a suitable jack for safety
• Slide or press the foot pad onto the appliance leg until fully seated; the appliance sits level and stable
• Re-check level after a short test run and adjust feet as needed

Rear leveling foot

This leveling foot threads into the base of your appliance to support and stabilize it. Adjusting the foot helps level the cabinet, reduce wobble and vibration, and keep doors aligned for smooth, reliable operation. Also called a leveling leg. What it does:

• Provides an adjustable contact point to stabilize the unit on the floor
• Helps level the cabinet so doors align and seal properly
• Reduces rocking, rattling, or excessive vibration on uneven surfaces
• Replaces a cracked, stripped, or missing leveling leg

• 1 leveling foot

• Unplug the appliance and turn off water supply if applicable
• Use a helper to carefully move or tilt the unit; support it securely
• Unthread the damaged foot; thread in the new foot by hand, then fine-adjust with a wrench
• Level side-to-side and front-to-back; ensure all feet make firm floor contact

The Leveling leg is an OEM component specifically designed for GE washing machines. This accessory provides stability for the entire unit during operation. 

Symptoms of a bad Leveling leg can include:

• Excessive tipping or leaning of the washer during operation   
• Walks or moves across a tile floor while operating  
• Deterioration like rust developing or cracks appearing

Causes involve long-term exposure to vibration and cycles of weight variations inside the washer. Over time, wearing down can potentially compromise support.

This GE replacement part is also compatible with Hotpoint, RCA and select Kenmore models. 

Restore stable, level support with this replacement leg assembly. The adjustable foot steadies the unit on uneven floors, reducing vibration and rattling while allowing precise leveling for proper alignment and smooth, reliable operation.

• Provides adjustable support at the base of the unit
• Helps keep the appliance level on uneven or sloped floors
• Reduces wobble, vibration, and rattling noises
• Promotes proper door alignment and closure
• Replaces stripped, cracked, or missing leg assemblies

• Disconnect power; shut off water supply if applicable
• Carefully tilt and support the appliance to access the leg area
• Unthread the old leg; hand-thread the new assembly to avoid cross-threading, then fine-adjust with a wrench
• Level front-to-back and side-to-side; confirm stability before use