Frigidaire Parts

Replaced two crisper drawers and a door shelf. The person who took my order was helpful and thorough in determining what I needed. The company was equally helpful when I needed to return some parts that I ordered which I turned out to not need. Read more

• Shakes and moves
• Noisy

I watched the video posted by Jerrod Sessler on yellow van handyman.com. Then I had to unstack the dryer from the washer, remove all covers, disconnect all hose connections, shock mounts and springs and remove the tub assembly. Then I disassembled the tub assembly and remove seal and both bearings from the rear half. At this point I cleaned everything. I installed new bearings and seal, installed the basket and assembled both tub halves using a new gasket and silicone, and reinstalled the... Read more

Bought a new water filter. Read more

This was a 2000 model so rather than just replace the defrost timer which was visibly burnt on the terminals, we just did everything. The cold control, defrost timer, thermostat, defrost heater and the compressor capacitor were all replaced. I had the same issue on my older unit and tore it apart replacing one item at a time over a three month period so on an older one i suggest do it all while it is apart. Read more

We are very inexperienced appliance repair people. Thus check it out first to see if we can fixit...successs. First checked to be sure it wasn't the actual switch. Did this by numbering the wires and then switching the two switches b/w the right and left front dual burners. Success, the switch was fine but kinda disappointed cause this part was less expensive. Proceeded to then order the left front dual burner. Arrived in a few days, packed well. We unplugged the appliance, as it been a... Read more

My kids are rough on stuff...including the bins on the refrigerator doors! One completely broke, and two cracked. It was super easy to order and install replacements, and our frig looks new again. Read more

• Door won't close
• Won't start

The very easy diagnosis was motor seizure. Because the machine is about a decade old, I decided to renovate most of the guts. My DIY project included replacing the motor, blower, drum bearing, belt, and door hinge. The end result is a functional dryer with no left-over parts. Lack of parts and hardware challenged the effort. For example, the blower assembly did not have the slide capture for the motor. I had to use the old one which is showing its age. With the exception of the drum... Read more

I first felt along each heating element (bake and broil) hoping to find a rough or blistered place on them. But they were both smooth with no irregular places. (replacing the elements would have been the easiest and cheapest repair. Pulled the back off the range (unplugged, of course) - checked wiring. There were no loose connections or burned wiring. I disconnected the elements and checked them with a ohmmeter (VOM) and both had continuity. Discovered that both elements used the same... Read more

Replaced racks, Read more

I paid to have a repairman diagnose the problem, HOWEVER, after submitting a quote for repair I knew that it was a ripoff to take advantage of us. He said the prices for the part and labor was given to him by his company. The part (evaporator fan motor) cost me under 40.00 from AppliancePartsPro, yet they wanted 90.00 for it. The labor charge they quoted was 190.00 to install the fan motor, yet after googling the day to install it, it took 10 minutes, had to remove 6 screws and unplug the... Read more

Ordered the part from AppliancePartsPros, snapped the old one out and snapped the new one in! Read more

Removed old seal and replaced with with new seal. It took approximately 5 minutes, the new seal just snaps in on this model of refrigerator. Also, the new seal came nicely boxed to prevent wrinkles. Read more

Looked up the model number on the internet, found a diagram on AppliancePartsPros.com which led to part number for the user interface, also found "how-to video" on-site that included how to remove user interface panel. When the part came it was an easy fix, remove defective user interface panel - remove 2 screws mounting lip, then remove 2 screws mounting panel, unplug 4 connectors in back, plug connectors into the new panel, mount new panel, and re-mount lip. Less than 10 minutes, the panel... Read more

• Ice maker dispenses too little ice
• Not dispensing water
• Ice maker not making ice

Replaced filter Read more

I ordered this glass and used a youtube video to replace the shattered glass step-by-step. I was a bit wary of doing this work myself, but it proved to be a snap. Within an hour of finding this package on my front porch, I had the oven as good as new. Read more

I originally ordered the Fan motor from a appliance dealer. I waited for 5 days for it to arrive. In the meantime I scavenge a motor from a junk refrigerator from the dump. It worked while I waited for the motor from the appliance dealer. When I picked it up 5 days later it was the "wrong" part. I was fuming mad. I went online and found you guys and ordered the correct parts in 5 minutes. It arrived in 1 day and a half, "COOL" ! The repair went quick and smooth and now the refrigerator runs... Read more