Need Help?
Call
Foam insulation wraps around your refrigerator's water reservoir. Replace if torn, crushed, missing, or compressed to prevent tank sweating and condensation.
Our refrigerator takes care of my wife and I, along with our children when they visit, and the grand kids. Over the years, it's seen its fair share of wear and tear. Thankfully, nothing major has happened that hasn't been able to be repaired right here in the home, and by me. Our refrigerator is a GE side-by-side with an ice maker/water dispenser, and has held up well. I've ordered parts for it from AppliancePartsPros.com for all of its repairs, and while GE/Frigidaire have been changing out a... Read more
Replaces the water filter in your refrigerator to bypass filtration. Installs in the filter housing to maintain water flow when a filter isn't needed.
Easy fix, just like replacing an old water filter. Read more
Ice maker not filling or water spilling? This fill cup directs water into the ice maker mold for proper ice production. Simple clip-on install.
Went online to appliance pro, found my model and the ice maker part number. The process was very easily. The order process was also very simple and the part was delivered promptly with installation instructions. Read more
Replaces a broken, cracked, or missing freezer shelf module in side-by-side refrigerators. Installs in factory side supports for organized storage.
Restores airtight seal on French door refrigerators. Replace when torn or loose to prevent warm air entry and condensation. Verify fit with your model.
Replace with new Read more
Internal water reservoir with attached tubing that stores and delivers chilled water to the dispenser. Replace if cracked, leaking, or damaged.
Installing the tank went quickly. Removed the water filter from the upper compartment to stop water flow to the tank. Had to remove the two lower drawers (they tilt out of their sliding frames). There is a glass shelf that should be pulled out - it slides out via two notches in the front frame. The water tank is behind a white metal cover held by 4 screws. Keep track of all of the parts including the lip seals from the shelf. I used two Watts 5/15x5/16 couplers from Lowes for the connections.... Read more
This is a refrigerator ice and water dispenser drip tray located on the freezer door. Color: White. It measures about 8 inches wide by 4 inches deep. For black order WR17X11655.
Ordered the new interface display - this must be the easiest refrigerator repair possible. My version popped right off without even a screw (some models have a screw). There are 3 different sizes of connector to disconnect and hook up to the new board - so you really can't mess that up. Read more
This white ice dispenser paddle is the lever you press on the freezer door to release ice. Replacing a worn or broken paddle restores reliable ice dispensing and a clean, like-new look at the dispenser.
After reading posts on the problem I concluded that the motor and solenoid was OK because I was getting water shooting out in the water line before the water entered the freezer door. At the bottom of the door there is a quick disconnect to check the water before it goes into the freezer door. So, I concentrated on looking at the mechanism that dispensed the water because I read a post that said that the water usually freezes right in the hose before it comes out of the dispenser. I used a... Read more
Secures the lower edge of the evaporator assembly inside your refrigerator. Replace if cracked, broken, or missing to restore proper alignment.
Ordering the above parts I was able to solidly secure and align fan which got me up and running. Easy fix. Read more
Dispenser paddle assembly for side-by-side refrigerators. Installs on the door to activate water and ice dispensing. Replace if cracked or broken.
Replacement trim for the dairy compartment on your refrigerator door. Restores a clean, finished look when the original is cracked, broken, or missing.
Replaced them. Read more
Seals your freezer door to keep cold air in and moisture out. Replace when worn, torn, or loose to restore temperature control and reduce frost buildup.
The gasket seemed to be worn out. So I replaced it. Read more
Replaces a cracked, broken, or missing evaporator door flap in your refrigerator. Controls airflow from the evaporator to maintain stable temperatures.
Fix a blank or unresponsive ice and water dispenser display. This touchpad interface assembly restores control panel function. Moderate DIY repair.
I replaced the Dispenser's Interface board assembly Read more
Fix a non-responsive display, blinking lights, or cooling failure. This power supply board restores proper voltage to electronic controls and displays.
It needed a new control board . I replaced the same board 6 years ago Read more
Fix clicking sounds and warm temps with this start relay and overload protector. Controls compressor start-up and prevents overheating. 15-minute DIY fix.
We replaced the main circuit board and the LED started to work and the condenser fan worked, but all we had were relay clicking sounds, but no cooling. The compressor had become so hot trying to work when the main circuit board was amiss, that it had popped the over temperature sensor on its side. As some one point out, if you remove the PTC+OLP assembly with the capacitor on it, and shake it, you will hear a rattle inside---and that is bad. We ordered a second round of parts from... Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.