Maytag Pump

Replaced the pump, had a plumber clean out the clogged pipe Read more

Found dryer portion I let plastic had failed to keep seal. Ordered new blower assembly and inlet cap. Gasket comes with blower. Read more

Turned my washer over and the pump was right there at the bottom didnt even need any tools, it had a kids sock stuck in it, I could not unjam it so I got this new pump, you just take the old one out and put the new one in Read more

Removed the 4 Torx (T-20) screws to remove the bottom tray, loosened the 2 steel adjustable hose clamps and disconnected the hoses from the old pump. Removed the 2 Torx screws from the drain pump mounting bracket and the 2 that mount the pump to the bracket. Discarded the old pump, reversed the above process for installating the new pump and the dishwasher is functioning normally again. All in well under 30 mins. Read more

Ordered pump, popped it in. Hardest part was walking down the stairs Read more

Figured it was either the capacitor and/or motor. Ordered both parts to be sure. tried changing the capacitor first; same problem. Replaced the motor (leaving the new capacitor in place). Unit now works fine. Overall an easy fix once you get the washer out and tip it on its side or top to get access to the motor area. Read more

Replaced Pump-water motor. Read more

• Noisy
• Will not drain

I had previously disassemble the pump assembly to find what I at first thought was an oddly shaped spring, which it was. What I learned by researching the parts was that the spring's odd shape was a result of something having gotten caught in the pump and jamming the impeller. After ordering the parts, I watched the "repair video" a few time and proceeded to remove and replaced the affected parts. Reassembly went pretty much as described with the one small glitch being the seating of the new... Read more

My dishwasher quit cleaning dishes and lost all pressure. The food screen would keep clogging up and I would have to take it out and clean it by hand. After putting a new impeller in, the "gears" on the impeller connected with the screen blades, the old impeller the "gears" were stripped off. And the new impeller comes with new seals, after taking old one out I noticed it wasn't long before my old seals would have started leaking. Very simple repair if you watch the great video that... Read more

Removed and replaced diverter motor. Ops check good, no more leaking. I'm guessing the seal was the problem but diverter ruined (water residue) from leaking over the last 5 years??? This seal is only available if you buy the tub so followed another review - removed diverter then gently pried out the seal, cleaned and then lubed with silicone grease. Also turned the seal 180 degrees or the opposite way before reinstalling the diverter and then wrapping it all back under the counter. Read more

I reviewed the schematic and saw the Volute Seal, and Impeller Seal were the two that were closest my source of water. After watching the video about changing the Impeller/seal I removed the motor, impeller, and volute; I found that the impeller seal was the faulty one in my case. Since I'd ordered the volute and impeller seal kits (as I wasn't sure which it was) I installed both while I had it apart. Runs great, no water - simple to do. The seal changes took about 20 minutes. The only... Read more

Minimal tools - nut driver and a torx screwdriver The only surprise was how fast the part was delivered. The speed of fulfillment I've experienced with APP has been an unexpected positive for each of my orders. Read more

Changed the parts and the machine now is quiet and runs like new again. Read more