Gas Conv Kit Parts

By putting on the part. Read more

We bought a stove off Craigslist and didn't realize it was LP Gas until we got it home and my husband was hooking it up and the burners wouldn't light all the way around. My husband has been out of the gas company for over 10 years now and was a little rusty on what was happening. I jumped online and when I read that the possibility was because LP Gas, my husband said..."thats it." So we jumped online... on a Sunday and actually got a real person to chat with at AppliancePartsPros who told... Read more

The oven was not heating, and there was no gas flow to the oven or spark. I replaced the spark igniter, but that did not fix it, so the problem was either the ignition device or the oven bake solenoid. In order to get to them, I had to cut the venturi tubes which hold down the burner rings with a Dremel tool, which was easy enough. There is no other way to get these tubes out if they are stiff or seized as you will simply twist the gas supply line to the burner if you try to rotate the nut.... Read more

Repair man replaced burner and screws. Used stainless screws because original rusted in and broke off when trying to remove them Read more

Changed out orifices in top burners. Read more

We change Orifice from Natural to LP I have a question do I need to get special part for the oven ? Read more

A word of caution - Due to not fully analyzing the situation upfront, I ultimately replaced more parts than necessary. So don't forget to check the spark module (the little electronic gadget that powers all the igniters), rather than jumping to the conclusion that the individual igniter or associated igniter cord is the problem (as I mistakenly did). Still, even with those additional replacements, the repair proved quick and easy thanks to the wide stock and helpful videos of APP. Plus the... Read more

Replaced the pilot orifice spud. Along with the burner base and head. Read more

REMOVE THE TOP COVER OF THE STOVE. THE VENTURI NUTS WERE FROZEN.WITH THE JET HOLDER I HAVE TO CUT OR DRILL OUT THE VENTURI NUTS TO RELEASE THE STOVE COVER. IN DOING SO THE JET HOLDERS WERE ROTATED RELATIVE TO THE MOUNTING BRACKET, AS A RESULT, THE TWO TUBING ASSEMBLIES WERE BROKEN. I ONLY FOUND ONE TUBING ASSEMBLY ON LINE. THE OTHER ONE I HAVE TO ABRICATE WITH 1/4" COPPER TUBING, COMPRESSION COLLARS AND WITH THE TWO NUTS SALVAGED FROM THE BROKEN PARTS Read more