Burner & Related Parts

In an attempt to clean the range from the grease-gunk build-up, I had to remove the burner heads. Unfortunately, the 2 most used burner heads had immovable screws that locked them into the orifices underneath. After numerous hours in attempts to salvage the old burner heads and orifices attempting to remove the immovable screws, I gave up. Checked Maytag's website for parts and found nothing. Turned to AppliancePartsPros.com and found the correct parts for reasonable price in a matter of... Read more

Ordered new/replacements, excellent chat on line, Quick turn around delivery. Thank you Will recommend to friends. Read more

Replaced both the valve and igniter. Hope they last for more than 4 yrs! Read more

In an attempt to clean the range from the grease-gunk build-up, I had to remove the burner heads. Unfortunately, the 2 most used burner heads had immovable screws that locked them into the orifices underneath. After numerous hours in attempts to salvage the old burner heads and orifices attempting to remove the immovable screws, I gave up. Checked Maytag's website for parts and found nothing. Turned to AppliancePartsPros.com and found the correct parts for reasonable price in a matter of... Read more

Conversion kit said put propane orifice .109 in to correct the problem but I had to use the .102 orifice. Read more

• Gas igniter glows, but will not light

Received all parts as ordered and it took about a half hour to change out all parts. Read more

Bought black ones to replace them. They look great and match the black burner grates and pans I had bought previously. Good service from you. Read more

I bought a new orifice and installed it. Read more

After turning off the gas and unplugging the electricity, I removed all the burners from the stove top using a 3/16" hex socket. Then used a 1/4" socket to removed two or three screws under each burner which hold the burner base to the bottom of the top panel. Then pulled all the knobs and removed the front panel which was held in by two Phillips screws accessible from underneath the panel. It helps to open the oven door to get at these screws. With the knob panel gone, I removed two screws... Read more

Ordered replacements Read more

Found that the gas line did not have a dirt trap put in it. So I put one in. I think the regulator valve was not closing off. To be safe, I replaced the gas safety valve and regulator. Read more

Found the parts I needed ordered them from your site Received them and installed in a few minuets and was done Read more