Plug Or Insert

Almond-colored plug insert for refrigerator front grille. Replaces cracked, broken, or missing grille plugs. Fills holes in the grille assembly.

White button plug insert for refrigerator interior. Fills and covers mounting holes in liner. Replace if cracked, broken, missing, or discolored.

This is a large bisque button-style plug designed to fill a control or panel opening and restore the appliance's finished appearance. It replaces a lost or damaged plug to keep interiors and controls protected and looking complete. What it does:

• Covers an unused or damaged round panel opening to restore the original look
• Helps keep dirt, moisture, and debris out of the control cavity or mounting hole
• Matches bisque trim for a near-original cosmetic match
• Commonly used where a larger "closer" hole needs a finished button plug

• Push-fit design; press into the hole until flush with the surrounding surface
• Disconnect power to the appliance before removing panels or working near controls
• If the plug sits behind a bezel or clip, remove necessary trim per manufacturer instructions

White button plug insert for refrigerator interior. Fills small mounting holes on shelves or door compartments. Replace when cracked, missing, or worn.

This push-in plug button is a small replacement cap that covers and seals an unused opening or socket on compatible appliances, keeping the area clean and helping prevent debris and moisture entry. What it does:

• Covers an unused plug hole or access port to block dust, dirt, and moisture.
• Provides a finished appearance by hiding raw openings in panels or control housings.
• Helps keep internal components protected from contaminants that can affect operation.
• Snaps into place for a secure fit without adhesives.

• Disconnect power to the appliance before accessing panels or openings.
• Typically installs by pressing into the opening until it snaps flush; no special tools required.
• Verify correct fit and orientation before final reassembly.
• If panel damage is present or the button does not seat securely, inspect mating opening or surrounding clips.