Range / Cooktop / Oven Switch
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3147265
Exhaust fan won't turn off or stuck on? This rocker switch restores reliable blower control. Simple 5-minute fix—just disconnect wires and snap in new.
Do-It-Yourself Stories from Customers like You
Rocker switch for exhaust fan just fell off Carol B. • Estill Springs , TN • February 01, 2017
SSVD48600Pon finally popped the control panel loose from the top of the stove. Took some manipulation as the stove is more than 20 yrs. old With a screwdriver finally popped the switch loose.
Applied the new switch. Popped the top back to the control panel. Put the screws back in and everything was back to normal.
Read more
More
$72.95
- Compare At:
-
$87.54
- You Save:
-
$14.59
Genuine Whirlpool part
By: Whirlpool
Part Number: WP74011489
Fixes burner that won't heat or indicator light stuck on. This infinite switch controls surface burner power and heat settings. Moderate DIY repair.
Do-It-Yourself Stories from Customers like You
Knob twisted off Glenn M. • Aurora , OR • August 20, 2018
Replaced switch
Read more
More
$78.75
- Compare At:
-
$93.71
- You Save:
-
$14.96
Genuine Samsung part
By: Samsung
Part Number: DG44-01003A
This is a selector switch that controls a surface burner element on an electric range. It allows you to select different heating zones or power levels for a multi-ring burner. Replace this switch if the burner does not respond to the control knob, only heats on certain settings, or if the switch fails to cycle the element properly.
Do-It-Yourself Stories from Customers like You
Burner indicator light stays on always Joseph S. • Waldron , AR • August 02, 2015
Replaced DG44-01003A (AP4336838) Energy regulator. Fixed it with no problem.
It was the the big burner on my Samsung range that had three settings for pot size.
Read more
More
$197.95
- Compare At:
-
$237.54
- You Save:
-
$39.59
Genuine Ge part
By: Ge
Part Number: WB24K5083
Fix burners that won't spark or click constantly with this igniter switch. Mounts on the gas valve stem to activate spark ignition. Easy 15-minute repair.
Do-It-Yourself Stories from Customers like You
Clicking from ignitor mode would not stop after burner lit Jeffrey Maclachlan V. • Nederland , CO • September 03, 2017
Turned out the little switches on the knob shaft had corroded and were staying on. There was constant continuity showing with an ohm meter. Replacing the switches was very easy (always disconnect power to the unit before servicing). Bought a new ignitor module as a backup as they do go out of production after 10 years or so- another cheap and easy fix if needed in the future.
Read more
More
$25.61
- Compare At:
-
$30.73
- You Save:
-
$5.12
Genuine Frigidaire part
By: Frigidaire
Part Number: 316445500
Oven light stays on or won't turn on when door opens? This door-activated switch restores automatic light control. Easy 15-minute DIY repair.
Do-It-Yourself Stories from Customers like You
Oven door wouldn't lock & oven light stayed on Michael B. • Dubois , PA • November 26, 2015
Replaced light switch
Read more
More
$59.50
- Compare At:
-
$70.80
- You Save:
-
$11.30
Genuine Whirlpool part
By: Whirlpool
Part Number: WP4456901
Fix sparking or non-working igniter switches with a new switch harness. Connects control switches to cooktop wiring. Moderate DIY repair, 1-2 hours.
Do-It-Yourself Stories from Customers like You
Igniter not working. Adrian H. • Totowa , NJ • January 18, 2022
Replaced the Spark Module and the Wire Harness. Works like new.
Read more
More
$117.54
- Compare At:
-
$139.87
- You Save:
-
$22.33
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3191049
Fix a burner that won't heat or has no temperature control by replacing this 6-inch element switch. Restores smooth low-to-high heat adjustment in 30 minutes.
Do-It-Yourself Stories from Customers like You
2 of 4 burners lost variable heat finction James R. • Centreville , VA • August 04, 2015
Trial and error only cooktop unit. Everything mounted into the counter and needed to pull unit out. I figured it was a control switch or the burner itself. Based on costs, I took the less expensive route and replaced the 2 known malfunctioning switches. All on-line videos said it was a 2-3 hour process to replace. I finished mine in less than 30 minutes. Turned breaker back on and it works like a charm. 30 years old and still going strong.
Read more
More
$83.36
- Compare At:
-
$100.03
- You Save:
-
$16.67
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304528828
Fix intermittent burner failures or electrical issues with this range wiring harness. Restores power flow when connections are loose, burnt, or broken.
More
$80.95
- Compare At:
-
$95.52
- You Save:
-
$14.57
Genuine Whirlpool part
By: Whirlpool
Part Number: WP74008248
Burner won't heat or dual-ring stops working? This dual infinite switch restores power control to both circuits of your cooktop element. Moderate DIY repair.
Do-It-Yourself Stories from Customers like You
I was hanging a light above the cooktop and put my foot on the edge of the glass and my wife heard the glass snap Robert C. • Lyman , WY • February 04, 2017
I looked up the parts on appliancepartspros.com, made the order, and was amazed how fast the parts arrived! I was able to watch their repair video and it showed me how to change it step by step.
Read more
More
$63.65
- Compare At:
-
$81.36
- You Save:
-
$17.71
Genuine Whirlpool part
By: Whirlpool
Part Number: WPY704512
If your gas burner won't light or clicks continuously, this igniter switch mounts on the valve stem to restore reliable ignition. Takes 5 minutes to replace.
Do-It-Yourself Stories from Customers like You
Front right burner would not light all other burners worked fine Kurt Z. • Austin , TX • February 06, 2015
By replacing the switch, the front right burner correctly turned on the igniter and worked. Repair took about 5 minutes. Very easy to do.
Read more
More
$64.70
- Compare At:
-
$76.35
- You Save:
-
$11.65
Genuine Whirlpool part
By: Whirlpool
Part Number: 12002792
Burner won't spark or ignite? This surface burner ignition switch triggers the spark module when you turn the knob. 45-minute DIY repair for ranges.
Do-It-Yourself Stories from Customers like You
Igniter switch shorted out Jeff J. • Hoffman Estates , IL • October 11, 2016
Replaced switch assembly
Read more
More
$102.32
- Compare At:
-
$121.76
- You Save:
-
$19.44
Genuine Whirlpool part
By: Whirlpool
Part Number: WP74009254
The fan control switch is the panel-mounted switch that sends power to the appliance's fan motor. Replacing a worn switch restores reliable on/off control and proper airflow so the fan starts and stops when it should.
- Provides user-operated on/off power to the fan/blower motor
- Helps regulate airflow for cooling, venting, or convection depending on model
- Typical symptoms: fan won't run, runs continuously, intermittent operation, or a loose/broken switch shaft
- Mounts behind the control panel and is actuated by the exterior knob/lever
What's included: One fan control switch Install notes:
- Disconnect power at the breaker before servicing
- Remove the control knob/actuator and panel trim to access the switch
- Note wire positions or take a photo; transfer wires one at a time to the new switch
- Secure with the original hardware, restore power, and test operation
Do-It-Yourself Stories from Customers like You
The fan switch on our jenn air cooktop broke Jonathan B. • Bend , OR • March 29, 2015
After looking at several YouTube videos that were only moderately helpful for my particular model, I disconnected the power at the breaker, disconnected the wires below the cooktop to the junction boxed lifted the whole unit out, including the fan assembly. I flipped it upside down and took off the screws holding the unit to the glass top. Although the new fan switch did not look the same as the original switch, the new switch does fit. The new switch did not come with a hex nut. The old hex...
Read more
More
$135.31
- Compare At:
-
$161.02
- You Save:
-
$25.71
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10295048
If your electric range burner won't heat properly or won't turn off, this infinite switch controls power to the surface element. Moderate DIY repair.
More
$84.95
- Compare At:
-
$101.09
- You Save:
-
$16.14
Genuine Ge part
By: Ge
Part Number: WB18T10452
Fixes continuous clicking or burners that won't spark when you turn the knob. This harness connects knob switches to the ignition circuit. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
All igniters sparked continuously when all burner gas switches were turned off Donald A. • Palatine , IL • October 03, 2018
Refer to Mynor T. of Draper, UT Aug. 12, 2018 write-up.
I benefited greatly from the above write-up. It took me a little less time to perform this repair (excluding cleaning the assembly) due to the write-up.
This GE Profile gas burner cook top is a “drop-in” model meant to be installed into counter top cut outs. The glass top edges are the actual support area for the entire cook top assembly. The burner bases (on top of the glass top) are screwed to the metal case enclosure (located beneath...
Read more
More
$72.95
- Compare At:
-
$87.54
- You Save:
-
$14.59
Genuine Whirlpool part
By: Whirlpool
Part Number: WP4456836
This blower speed switch lets you select the blower/fan speed to restore proper airflow control in your appliance. It replaces a worn or faulty speed selector so the blower will respond correctly when you change settings. What it does:
- Controls the blower/fan speed so the appliance can run at selectable airflow levels
- Replaces a switch that is stuck, unresponsive, or only running at one speed
- Restores reliable electrical connection between the control circuit and blower motor
- Helps eliminate intermittent fan operation or loss of speed selection
What's included: One blower speed switch Install notes:
- Disconnect power to the appliance before starting any repair.
- Verify wiring placement and retain original fasteners; wiring diagram for correct connections.
- Handle terminals carefully to avoid bending or damaging contacts.
Do-It-Yourself Stories from Customers like You
Broken fan switch on my kitchenaid electric cooktop Joseph H. • Winter Haven , FL • May 12, 2014
Went on line to find the part number. Once I had the number I searched for the part. Found it, had it shipped overnight and installed it with the help of a video from youtube.
Read more
More
$120.56
- Compare At:
-
$142.26
- You Save:
-
$21.70
Genuine Frigidaire part
By: Frigidaire
Part Number: 316219019
This wiring harness routes power and control signals between key components inside your range or wall oven. Replace a damaged harness to restore safe, reliable operation and prevent intermittent heat, shorts, or non-working burners and oven functions.
- Distributes electrical power and signals between controls, switches, heating elements/igniters, and safety components
- Maintains correct connector orientation and wire routing for dependable operation
- Typical symptoms: no heat in oven or on surface burners, intermittent operation, breaker tripping, or visible burnt/melted wiring
- Restores stable connections to reduce arcing and overheating
What's included: One wiring harness assembly. Install notes:
- Disconnect power at the circuit breaker; for gas ranges, also shut off the gas supply
- Label or photograph all connections and transfer one wire at a time to avoid miswiring
- Route the harness exactly as original; keep away from sharp edges and hot surfaces; secure with existing clips/ties
- If connectors don't match or any terminals are heat-damaged, stop and inspect mating components.
Do-It-Yourself Stories from Customers like You
One of the stove controls would not lite the burner. Duane F. • Roulette , PA • March 17, 2019
I replaced the wiring harness and the stove worked like new again.
Read more
More
$74.31
- Compare At:
-
$88.43
- You Save:
-
$14.12