Washer Hose Or Tube

This hose connector joins washer plumbing lines to the appliance so water flows securely where it should. It replaces a worn or damaged connector to help stop leaks and restore proper water routing. What it does:

• Connects a washer hose to the appliance plumbing to maintain a watertight path
• Helps prevent leaks caused by cracked or split connectors
• Restores reliable water flow when a failed connector is the source of drips or poor sealing
• Works with existing hose clamps and fittings when in good condition

• Disconnect power and shut off the water supply before servicing
• Drain residual water from hoses to avoid spills during replacement
• Inspect hose ends and clamps; replace clamps if corroded or damaged

This replacement fill hose routes incoming water from the inlet valve to the washer tub so the machine fills properly. It restores proper water delivery and helps stop leaks caused by cracked or damaged hoses. What it does:

• Carries water from the inlet valve to the wash tub during fill cycles
• Prevents leaks and water loss when intact and securely clamped
• Can cause slow or no-fill symptoms if kinked, split, or detached
• Works with the washer's existing inlet valve and hose clamps

• One fill hose

• Turn off power and shut off the water supply before installing
• Inspect and reuse or replace hose clamps and any sealing gaskets as needed
• Route the hose without kinks and secure to the inlet valve/tub connections
• Check for leaks after restoring water and power

This inlet hose routes household water into the appliance and replaces a damaged or worn water supply line to restore proper filling. Durable, flexible hose for a secure connection at the appliance fill valve. What it does:

• Carries water from the household supply to the appliance fill valve during fill cycles
• Replaces cracked, split, or collapsed hoses that cause reduced or no water flow
• Helps stop leaks at the supply line when the original hose fails
• Useful when water delivery is intermittent or the appliance won't fill

• One inlet hose

• Turn off water supply and unplug the appliance before starting
• Confirm correct orientation and push/ threaded connections; tighten fittings by hand then snug with a wrench—avoid overtightening
• Inspect seals/ gaskets and replace if damaged; test for leaks after restoring water