Washer Hose Or Tube

Siphon break hose assembly for washers. Prevents backflow into the tub. Replace if cracked, split, or leaking. Connects between pump and drain system.

Injector hose and clamp kit for washers. Connects the dispenser system to deliver detergent during cycles. Replace if cracked, leaking, or worn.

Pressure hose connects water supply to your washer tub. Replace if cracked, leaking, or worn. Direct fit installation for washer water circulation.

Replacement dispenser hose for washers. Connects detergent dispenser to wash tub. Replace if cracked, leaking, or damaged to restore proper dispensing.

Fill hose for washers. Connects water supply to the machine inlet. Replace if cracked, leaking, or damaged to restore proper water flow during fill cycles.

Upper drain hose with elbow fitting for washers. Replaces cracked, leaking, or damaged drain hoses that cause water drainage issues during wash cycles.

Replace your washer's drain hose when cracked, kinked, or leaking. This tube connects the pump to the drain outlet, routing wastewater out of the machine.

Flexible water hose that routes water between internal washer components. Replace when original hose is cracked, damaged, or leaking to restore proper fit.

Replace your washer's tub hose if it's cracked, leaking, or worn. This hose connects internal components to the tub for proper water circulation.

This pump hose channels washer tub water to the drain pump, restoring proper drainage and preventing leaks at the pump connection. Durable flexible tubing designed to match factory fit and routing. What it does:

• Transfers wash water from the tub to the drain pump for normal draining
• Replaces cracked, collapsed, pinched, or leaking pump hoses that cause poor drainage
• Helps stop leaks that can occur where the tub outlet connects to the pump
• Restores reliable water flow when the original hose is brittle or damaged

• Disconnect power and water before installing; follow all safety precautions
• Inspect clamps and surrounding fittings; replace clamps if damaged or corroded
• Ensure proper routing and secure clamps to avoid kinks or contact with moving parts
• Test a short cycle after installation to check for leaks

Replaces a damaged or worn washer hose and spring assembly. Installs in the drum area. Order this part if your original hose is cracked or leaking.

Replace your washer's pressure switch hose if cracked, kinked, or leaking. This tube connects the pressure sensor to the tub for water level control.

This vent hose directs dryer exhaust from the appliance to the home vent, helping remove moisture and lint so clothes dry efficiently and the dryer runs safely. It replaces a worn or damaged exhaust connection. What it does

• Channels hot, moist air from the dryer to the exterior vent to prevent moisture buildup.
• Helps reduce drying times when unrestricted and properly installed.
• Prevents lint accumulation at the appliance connection when intact.
• Common symptom: longer drying cycles or dryer overheating when the hose is crushed, disconnected, or damaged.
• Common symptom: visible lint buildup around the dryer outlet or exhaust connection.

• One vent hose.

• Disconnect power (and gas, if applicable) before servicing the dryer.
• Inspect clamps and the vent path; replace any damaged clamps or crushed ducting.
• Avoid sharp bends or kinks; maintain a smooth, short run for best airflow.
• Wear gloves to protect hands from sharp edges and lint; follow all manufacturer safety instructions.