Whirlpool Switch

Part easily replaced and problem was solved. Saved service call. Read more

• Won't start

I was searching the web for solutions and came across two folks who had similar trouble code. One fixed his by removing the pump strainer from the pump to find coins blocking water flow, thus the analog water pressure sensor provided a failure response. My issue was solved by following the other hints I got. I ordered a new sensor (switch). It was expensive for what it is, but the washer will not run correctly without it! The part arrived in a very timely manner, and it was the right part.... Read more

I was able to clean the Oven Temp Sensor with 99% alcohol. Then replaced All switches (after breaker was isolated). Put it all back the way I found it. Turned on breaker. Tested all functions and had no reports of Fan Code re-appearing since. Read more

Replaced two switches that controlled two front burners. One controlled three different burner sizes options in one burner. The other was the speed burner, basically three different burner options in one burner. Read more

Ordered the right part, took the back off the top control panel, and popped it in. Read more

Searched internet for answers. Decided to replace the door switch. Drier now runs great! Read more

Simple unplug, unscrew and replace. Read more

I replaced the assembly behind the water level knob. I watched the video on appliancepartspros.com before starting, and then watched it again in short portions while going thru the repair process. Read more

Replaced dual element switch. Fixed the problem. All is good Read more

First and foremost I UNPLUGGED THE OVEN!. I'll pass on the early morning SHOCK THERAPY! Second, I unscrewed aluminum protection plate from back of oven. Next, I unplugged the two connections behind the oven switch. Then I removed the plastic switch from the front and unscrewed the two screws that secured the oven switch to the oven. Once you've completed all these steps you take your new oven switch and do everything again but in reverse order. Hope this was informative, direct, and that your... Read more

Every time I tried to start our dryer, the "Sensing Light" came on, I heard a little "click," and the dryer would not start. According to the very helpful Appliance Parts Pros. videos, I was able to dismantle, diagnose a few components, and discover the broken part. In this case, it was a Broken Belt Switch. I ordered the part, we went on vacation for a week, and when we returned home the part was at our residence. The next day, I installed the part and all is good now. I am nearly 70 years... Read more

Replaced the burner Infinite switches for the burners having the issue. Here are the latest part numbers for this model Maytag. Left rear (LR) and right rear (RR) burners are both 6" and use the same switch. Part # WP3149404. Left front (LF) is an 11 1/2" burner Part# W10167742. The right front (RF) burner is a double burner 6" center and 9 1/2" outside burner Part #WPW10149355. Very simple repair. Unplug the stove, remove the rear panel, remove the switch knob, remove the 2 switch screws,... Read more

• No hot or cold water

I tested the Atc. mid level switch, with my multi tester and found it was not sending enough current to the cold water inlet valve, so it would not open and let cold water in. I replaced the switch, (it was a snap) literally it snapped in place. replace the front face and turned the water back on and plugged in the washer, and turned it on. It worked perfect and has been since. good and easy repair even for a novice like me.. Read more

Removed control panel and replaced broken switch. Much easier then expected. Read more