Bumper, Bushing, Grommet Parts

Black front trim spacer for wall ovens. Replaces cracked, broken, or missing spacers that support trim alignment. Installs between trim and frame.

Composite stud for range installation. Provides structural support and cushioning between components. Replace if cracked, broken, or missing during repair.

Spacer that positions and supports the grease filter in your range hood. Replace if cracked, broken, or missing to properly secure the filter assembly.

This rubber rangetop bumper cushions and supports the cooktop, reducing vibration and protecting the surface from metal-on-metal contact. It helps restore proper spacing and reduces rattling or chafing from loose or missing bumpers. What it does:

• Cushions the cooktop edge to prevent scratching and wear
• Keeps the cooktop and rangetop components properly spaced and stable
• Reduces rattling, vibration, and noise during use
• Commonly replaced when bumpers are cracked, flattened, missing, or allow movement

• Remove power to the appliance and allow all surfaces to cool before servicing.
• Access may require lifting or removing the cooktop; follow manufacturer instructions for your model.
• Replace with the same style bumper to maintain proper fit and spacing.
• Use care around sharp edges.

A replacement board supporter that secures the appliance control board to the cabinet, helping keep the board stable and positioned away from wiring and chassis. Restores proper mounting to reduce vibration and movement of the control board. What it does:

• Holds and supports the control/PC board to prevent excessive movement or rattling
• Keeps the board spaced from the chassis and wiring to reduce risk of shorting or contact
• Helps maintain stable electrical connections for reliable control operation
• Reduces noise caused by a loose or vibrating control board
• Can prevent further wear on board mounting points and connectors

• Disconnect power to the appliance before beginning any service.
• Handle the control board by its edges and avoid touching components; use ESD precautions if available.
• Remove nearby panels or components as needed for access; retain all fasteners for reassembly.
• If mounting points or fasteners are damaged, inspect nearby parts and replace as required.

Spacer component for oven doors. Maintains proper door alignment and spacing. Replace if cracked, broken, or missing to restore correct door fit.

Container bumper for trash compactors. Installs on the compaction container to cushion impact and reduce noise. Replace if cracked, worn, or missing.

Insulating sleeve for dishwashers. Installs around components to provide heat protection and reduce noise. Replace if cracked, worn, or missing.

Plastic sleeve bushing for dishwasher rack assemblies. Replaces worn, cracked, or missing sleeves that protect moving parts. Essential structural component.

Bushing that supports the washer lid hinge mechanism. Replace if cracked, worn, or causing the lid to sag or close improperly. Direct fit part.

Door bushing for refrigerators. Installs in door hinge assembly to cushion door movement. Replace if worn, cracked, or missing to restore smooth operation.

Door closure spacer for side-by-side refrigerators. Replaces broken, worn, or missing spacers that ensure proper door alignment and seal.

Refrigerator door stopper component that cushions and limits door movement. Replace if cracked, broken, or missing to prevent door damage and ensure proper closure.

Spacer component that fits on the temperature control shaft inside your refrigerator. Replace if the original is cracked, worn, or missing.

Refrigerator leg shim that installs under the leveling feet to stabilize your unit. Replace if worn, cracked, or missing to ensure proper alignment.

Rubber grommet that cushions and stabilizes the compressor in your refrigerator. Replace if cracked, deteriorated, or missing to restore support.