Bumper, Bushing, Grommet Parts

Rubber grommet that seals the water fill tube where it passes through the refrigerator liner. Replace if cracked, worn, or missing to prevent leaks.

Rubber grommet that cushions and secures the door/light switch assembly in your refrigerator. Replace when worn, missing, or cracked to restore fit.

Replacement door hinge shim for your refrigerator. Installs between hinge and door to adjust alignment. Needed when original is missing or worn.

Refrigerator door spacer that maintains proper spacing between door components. Replace if cracked, broken, or missing to restore correct alignment.

Plastic spacer that supports and positions freezer shelves. Replace if cracked, broken, or missing to restore proper shelf alignment and stability.

Rubber grommet that secures the drain tube in your refrigerator's drain system. Replace if cracked, worn, or missing to ensure proper tube fitting.

Spacer component for refrigerator water filter housing. Ensures proper spacing and alignment. Replace if cracked, worn, or missing to restore fit.

Replace your worn or damaged freezer door hinge spring bushing. This small plastic component cushions the hinge spring mechanism and prevents metal-on-metal contact. Installs inside the hinge assembly.

Replace your worn or missing refrigerator door bumper. This small plastic part cushions the door and prevents damage to the cabinet interior.

Plastic bushing that fits into the top hinge assembly on your refrigerator door. Replace if the original is cracked, worn, or missing to restore support.

Non-metal shim for refrigerators. Installs to provide spacing and alignment between components. Replace if worn, compressed, or missing to restore fit.

This is a small evaporator block (also called an elut block) used in the refrigerator's sealed system. It serves as a connection or mounting component for evaporator tubing, helping maintain proper refrigerant flow. Replace this part if you notice refrigerant leaks near the evaporator or if the block shows visible damage or deterioration.

Freezer drawer slide shim for bottom-mount refrigerators. Replaces worn, cracked, or missing shims that support smooth drawer operation.

Replaces worn, cracked, or missing refrigerator door spacers. Maintains proper door alignment and spacing between compartments for smooth operation.

This snap bushing cushions and centers a rotating shaft or spacer, reducing wear and vibration for smooth appliance operation. Fits applications that require a 1.00 inch inside diameter and 1.468 inch outside diameter bushing. What it does:

• Provides a low-friction bearing surface to protect shafts and surrounding components from metal-on-metal wear
• Centers and stabilizes rotating parts to reduce vibration and noise
• Helps maintain proper clearance between moving parts for longer component life
• Used where a durable, press-fit snap bushing is needed for quick assembly

• One snap bushing

• Press into a clean, burr-free hole until the bushing snaps fully into place; do not force at an angle
• Verify correct orientation so the retaining lip seats against the mounting panel
• Replace any damaged or excessively worn bushings to prevent further component damage
• Disconnect power and follow appliance safety procedures before accessing internal components

This is a shelf support bushing that secures oven racks or shelves in place inside the oven cavity. It mounts to the interior side wall and provides a stable resting point for the rack. Replace this part if oven racks are tilting, sliding unevenly, or if the original support is cracked or missing.