Bumper, Bushing, Grommet Parts

Replace your worn or damaged freezer door hinge spring bushing. This small plastic component cushions the hinge spring mechanism and prevents metal-on-metal contact. Installs inside the hinge assembly.

Replace your worn or missing refrigerator door bumper. This small plastic part cushions the door and prevents damage to the cabinet interior.

Plastic bushing that fits into the top hinge assembly on your refrigerator door. Replace if the original is cracked, worn, or missing to restore support.

Non-metal shim for refrigerators. Installs to provide spacing and alignment between components. Replace if worn, compressed, or missing to restore fit.

This is a small evaporator block (also called an elut block) used in the refrigerator's sealed system. It serves as a connection or mounting component for evaporator tubing, helping maintain proper refrigerant flow. Replace this part if you notice refrigerant leaks near the evaporator or if the block shows visible damage or deterioration.

Replaces worn, cracked, or missing refrigerator door spacers. Maintains proper door alignment and spacing between compartments for smooth operation.

This snap bushing cushions and centers a rotating shaft or spacer, reducing wear and vibration for smooth appliance operation. Fits applications that require a 1.00 inch inside diameter and 1.468 inch outside diameter bushing. What it does:

• Provides a low-friction bearing surface to protect shafts and surrounding components from metal-on-metal wear
• Centers and stabilizes rotating parts to reduce vibration and noise
• Helps maintain proper clearance between moving parts for longer component life
• Used where a durable, press-fit snap bushing is needed for quick assembly

• One snap bushing

• Press into a clean, burr-free hole until the bushing snaps fully into place; do not force at an angle
• Verify correct orientation so the retaining lip seats against the mounting panel
• Replace any damaged or excessively worn bushings to prevent further component damage
• Disconnect power and follow appliance safety procedures before accessing internal components

This is a shelf support bushing that secures oven racks or shelves in place inside the oven cavity. It mounts to the interior side wall and provides a stable resting point for the rack. Replace this part if oven racks are tilting, sliding unevenly, or if the original support is cracked or missing.

A glass spacer used to position and support the cooktop glass where it mounts to the frame. Restores proper spacing and alignment for a secure, even fit on compatible Bosch cooktops. What it does:

• Keeps the cooktop glass properly spaced from the mounting frame to prevent rubbing or uneven gaps
• Helps maintain a stable, even surface for burners and cookware
• Reduces stress on the glass by providing an intended support point
• Can address symptoms like a misaligned or wobbly glass top and uneven gaps around the edge

• Intended for the specified cooktop mounting location; verify exact placement before installing
• Turn off power to the appliance and allow all surfaces to cool completely before service
• Handle glass parts carefully and use appropriate gloves to avoid cuts