Bumper, Bushing, Grommet Parts

Sleeve bearing bushing that supports rotating shafts in washers. Replace if worn, cracked, or causing noise. Reduces friction and centers components.

Rubber grommet cushions wiring, tubes, or panels in your dryer. Replace if cracked, worn, or missing to prevent chafing and reduce vibration noise.

Rubber grommet that mounts and cushions the compressor to reduce vibration transfer. Replace if cracked, worn, or missing to restore quiet operation.

Black plastic shim that positions and stabilizes the refrigerator door for proper alignment. Replace if worn, missing, or cracked to eliminate door gaps.

Black rubber mounting grommet that secures tubes and wires in your refrigerator. Replace if cracked, worn, or missing to properly hold components in place.

Body-side spacer for gas range door or lid hardware. Installs on cabinet side to set correct stand-off and alignment. Replace if cracked or missing.

Grommet cover assembly for refrigerators. Installs over grommet areas to maintain a finished appearance. Replace if cracked, broken, or missing.

Bottom hinge bushing guides the refrigerator door hinge pin for smooth pivoting. Replace if worn, cracked, or missing to restore proper alignment.

Cushion bumper for washer installation. Absorbs vibration and protects cabinet surfaces. Replace if cracked, compressed, or missing to restore proper support.

Replaces worn or damaged shaft support bushing in your refrigerator. Cushions rotating shafts to reduce friction and noise. Order a new bushing today.

Positions and supports oven panels or components to maintain correct alignment and clearance. Replace if worn, missing, or broken to restore proper fit.

Rubber bumper cushions oven or range doors to reduce noise and prevent metal contact. Replace if cracked, worn, or missing to restore proper seating.

Replacement shelf spacer that attaches to wire shelves in your refrigerator or freezer to hold them securely in place. Needed when original is lost or damaged.

Rubber grommet that cushions and secures the refrigerator condenser assembly. Replace if cracked, worn, or missing to reduce vibration and noise.

A small replacement button plug that fills a control-panel or console opening and restores a finished appearance. Keeps panels sealed and prevents debris from entering unused holes. What it does:

• Covers unused control holes or mounting openings on consoles and panels
• Helps block dust, moisture, and grime from entering appliance internals
• Restores a consistent, finished look to the control surface
• Useful when a damaged or missing plug leaves an exposed opening

• One button plug (black)

• Typically snaps into place from the front of the panel; no special tools usually required
• Ensure the cavity is clean and free of debris before installing for a secure fit
• If the plug sits near electrical components, disconnect power to the appliance before servicing
• Verify fit against the opening before final installation; slight trimming is not recommended unless specified

Button locking mechanism secures control panel buttons in your microwave. Replace if broken, loose, or missing to restore proper button alignment and feel.