Bumper, Bushing, Grommet Parts

The refrigerator top hinge shim is a thin spacer that fits between the top hinge and the refrigerator cabinet to fine-tune the alignment and level of the door. It helps ensure the door hangs evenly, seals properly, and closes without gaps. Replace or add this shim if the refrigerator door sags, doesn't close flush, or the door gasket isn't sealing evenly around the top of the door.

Positions the transmission bearing block for proper alignment in your washer. Replace if worn, damaged, or missing to restore correct drivetrain spacing.

Rubber mounting grommet that cushions and isolates the compressor from the chassis. Replace if cracked, worn, or missing to restore proper support.

Door spacer for bottom-mount refrigerators. Maintains proper spacing between door panels and cabinet. Replace if cracked, missing, or worn to prevent rubbing.

Spacer for ranges and ovens. Maintains proper spacing between components. Replace if worn, cracked, or missing to ensure correct alignment and fit.

This is a small plug designed to fill an unused opening on the range's control panel or body. It provides a clean, finished appearance and prevents debris or moisture from entering the appliance through the open hole. Replace this plug if the original is cracked, missing, or no longer fits securely in the opening.

Replace a cracked or missing power board spacer in your range. This insulating bushing mounts between the control board and chassis for proper spacing.

Bushing for electric cooktops and ranges. Replaces worn, cracked, or missing bushings. Structural component that installs in the cooktop assembly.

Rubber bumper that cushions the oven door when closed. Installs on the frame to prevent metal-on-metal contact. Replace if cracked, missing, or worn.

Positions and supports range components to maintain proper alignment. Replace if cracked, broken, or missing to prevent rubbing and ensure panels fit correctly.

Rubber grommet that cushions and secures the refrigerator condenser assembly. Replace if cracked, worn, or missing to reduce vibration and noise.

This is a small rubber or plastic bumper that attaches to the console area of an ice machine. It acts as a cushion to prevent vibration noise and protect surfaces from impact during operation. Replace this bumper if it is cracked, missing, or deteriorated, which can cause rattling sounds or allow the console to shift out of position.

Replacement door grommet for refrigerators. Installs in the door assembly to seal and cushion components. Replace if cracked, worn, or missing.

Rubber grommet that seals the drain area in your refrigerator's interior. Replace if cracked, worn, or missing to prevent water leaks around the drain.

Rubber grommet that seals around the refrigerator suction pipe. Replaces worn, cracked, or missing grommets to prevent air leaks and maintain seal.

The screw and bumper assembly includes a small cushioning stopper and its mounting screw, designed to prevent hard contact between moving parts or doors and the appliance frame. These bumpers absorb impact and reduce noise when drawers, doors, or panels are opened and closed. Replace this set if you hear loud banging or rattling when operating your appliance or if the existing bumper is worn, torn, or missing.