Craftsman Parts

This ignition coil module generates the high-voltage spark needed to ignite the fuel-air mixture in a gas-powered string trimmer engine. It converts low-voltage current from the flywheel magnets into the spark that fires the spark plug. Replace this module if the trimmer has no spark, won't start, runs intermittently, or stalls frequently - especially after the engine warms up.

This impeller can be used as a replacement part for the small engine of a leaf blower or a leaf vacuum. The function of an impeller, which operates by rotation, is to take in the leaves and eject them out of the chute.An impeller might have to be replaced if it suffers damage that impedes it from properly ejecting the leaves from the chute. A common symptom of an impeller that needs to be replaced is that the leaves are not ejected with enough force from the chute or that the ejection process stalls or does not occur at all. If this is the case, the impeller should be removed and replaced with this genuine OEM replacement part immediately before using the leaf blower or leaf vacuum again. Remember to always wear gloves when handling, repairing, and operating outdoor equipment. This is an OEM part sourced directly from the manufacturer, MTD, and it is sold individually. This impeller is compatible with the following brands: MTD, Troy-Bilt, and Yard Man.

Replacement flex shaft for gas line trimmers. Connects the engine to the trimmer head. Replace if bent, broken, or worn causing vibration issues.

Blocks debris and dirt from entering the trimmer carburetor and engine. Replace at least once per season or more often in dusty conditions.

This is a ratchet pawl assembly used in the recoil starter mechanism of a string trimmer. It engages the starter pulley to turn the engine over when the pull cord is yanked. Replace this part if the pull cord pulls freely without engaging the engine or if the trimmer fails to start due to a slipping or broken starter pawl.

Blade guard assembly for line trimmers. Protects operator from debris and rotating components. Replace if cracked, broken, or missing for safe operation.

Engine o-ring gasket creates a compression seal between engine components to prevent oil and fluid leaks. Replace when worn or cracked. Verify fit with your model.

O-ring gasket creates a seal to prevent fluid and gas leaks in tillers and lawn equipment. Replace when cracked, brittle, or leaking. Verify fit.

Skid shoe kit for snow throwers. Mounts to the base housing to protect the auger from ground contact. Replace if worn, cracked, or missing.

This flywheel assembly mounts on the engine crankshaft of a gas-powered line trimmer and provides the rotational mass needed to keep the engine running smoothly between power strokes. It also drives the ignition system by passing magnets over the ignition coil to generate spark. Replace this flywheel if the engine has no spark, runs erratically, or if the flywheel is cracked, has damaged magnets, or a sheared keyway.

Throttle control cable for gas line trimmers. Connects trigger to carburetor for speed control. Replace if cable is frayed, stiff, or broken.

Carburetor assembly for edgers and gas trimmers. Mixes fuel and air for combustion. Replace if cracked, damaged, or leaking to restore proper operation.

Trimmer won't start or pull cord doesn't retract? This recoil starter assembly drives the engine's combustion process for hand starting your trimmer.

Ignition coil module for gas line trimmers. Mounts to engine block to generate high-voltage pulses for spark plug. Replace if cracked or damaged.