Need Help?
Call or text
Usually ships within 4 - 14 days
The Door Gasket is an OEM part for LG dishwashers. It forms a watertight seal around the dishwasher door, preventing leaks during the wash cycle. This gasket ensures that water stays inside the dishwasher, promoting efficient cleaning and protecting your kitchen from water damage.
Causes of a bad door gasket can include regular wear and tear, buildup of detergent residue, or damage from closing the door on obstructive items. Over time, the gasket can become brittle or cracked, compromising its sealing capabilities.
Symptoms of a bad door gasket include:
This OEM LG part is also compatible with Sears/Kenmore models.
Pulled out the old gasket. Then, found the middle of the new one and started in the top middle of the dishwasher and pushed the new one in and worked my way to the left and down the side and then the right and down the side. It did not seem long enough at first as it did not curve under at the bottom like the old one. I took it out and measured against the old one and it was a little shorter. So, I started again at the top middle and then pulled it taut as I worked my way around and down... Read more
The Tub Gasket is an OEM part for GE dishwashers. It creates a watertight seal around the dishwasher tub, preventing water from leaking out during the wash cycle and ensuring efficient operation.
You should replace the tub gasket if it becomes worn, cracked, or damaged. Causes of a bad tub gasket can include normal wear and tear from repeated use, buildup of detergent and food debris, or physical damage from sharp objects or improper installation.
Symptoms of a bad tub gasket include:
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
I ordered a new gasket from AppliancePartsPros.com. It was very reasonable and came within a few days. The old gasket was worn out and catching on the lower dishrack as it was being pushed in causing the gasket to be dragged out of it's seat. This is partially due to the design of the dishwasher where the gasket is mounted on the tub rather than the door. Upon inspection the gasket was obviously cracked and not seating correctly which exacerbated the interference issue with the lower dishrack.... Read more
The Lower Door Gasket is an OEM part for GE dishwashers. It forms a seal around the bottom of the dishwasher door to prevent leaks and contain heat, moisture, and harsh detergent within the wash chamber.
Causes of a bad gasket can include cracking, warping or tearing of the rubber seal over multiple usage cycles and exposure to hot washing conditions.
Symptoms of a bad lower door gasket include:
This OEM GE part can also be used on Hotpoint, RCA, and Kenmore/Sears appliances.
Replaced 3-sided gasket on washer & bottom gasket on door. 2.5 hours to do the former job. Most of this time spent cleaning old rubber & RTV glue out of groove. Followed instructions that came with new gasket. Wrapped edge of putty knife with 2 layers of electrical tape to avoid damaging gasket while pushing outside edge of gasket into groove. Latter job only took about 10 minutes. No glue involved. Had to spread groove ends a bit with screwdriver so that I could get the leading edge of the... Read more
This dishwasher flood switch seal sits around the flood/leak switch to create a watertight barrier at the switch opening. Replacing a cracked or flattened seal helps stop under-unit drips and keeps leak detection working properly.
Thanks to appliancepartspros.com the dishwasher was able to be repaired quickly and under budget. I removed the motor pump assembly and replaced it. I was also able to change out the faulty flood switch and replace the seals to stop the leak. The appliance is once again good as new and ready to run a new load of dishes. Read more
This O-ring creates a watertight seal in your dishwasher's wash or drain system, helping prevent leaks and maintain proper water pressure. Replace a brittle, flattened, or damaged ring to restore a reliable, leak-free connection.
Removed 8 screws that retain inner door to outer door. Removed rinse aid dispenser nut and replaced O-ring around dispenser. Also, removed 2 screws that retain the latch assembly and replaced rubber grommet around latch lever that retains soap dispenser door. Read more
Installed new washer took 5 minutes Read more
This baffle seal replaces the worn or damaged seal on the refrigerator door baffle to help maintain an even internal temperature and reduce drafts. It restores the baffle's edge seal to help limit frost and energy loss. What it does: